Vestil EXCNV-R-24-24 Assembly Instructions

  • Hello! I am an AI chatbot trained to assist you with the Vestil EXCNV-R-24-24 Assembly Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
EXCNV-R-24-24 Telescoping Roller Conveyor Assembly Instructions
1.
Orient
conveyor
sections
with
rollers down. Loosen four (4)
circled screws on both sides.
1
2
3
4
5
6
7
8
2
.
Use
from step 1 to
fa
sten leg brackets to
conveyor
.
3
.
Slide the cross bar onto
side
branches of
legs
.
Cross
bar
Leg
4
.
Insert
legs into l
e
g
brackets
(circled)
.
5
.
Fast
en each
leg
to
bottom bracket
with
M10x50 bolt & M10 nut.
6
.
Fasten
cross bar to
e
ach leg
with
M10x16
bolt
.
Threaded hole for knob
(step 7)
7
.
Wind
knob
in
to
threaded hole
of each leg.
8
.
Install
a caster
(
stem)
into
bottom of each leg.
Insert
caster
stem
into
leg
9
10
11
9
.
Parts
of
Stopper Assembly: 2 rods
with bolts; 2 stopper brackets
10
.
Turn
conveyor upright &
a
ttach
stopper
assembly to end of conveyor.
Remove bolts from
ends of rods; then
align rods with holes
in stopper brackets
and reinstall bolts.
Remove bolt & washers on both sides
of rod. Insert rod through slots in
stopper bracket. Reinstall bolts and
washers. Tighten bolts.
Bolt and
washers
Slot
Stopper bracket
Rod
Leg
brackets
11
.
Press (black) plastic caps into
leg bracket openings.
The capacit
y of this conveyor is
200 lb.
/ft.
(296
kg/m)
. Do not
exceed the capacity. Serious personal injury or death might result.
Do not shock-load the conveyor, i.e. drop loads onto it. Shock loading could damage the conveyor and make it unsafe to use.
WARNING
!
Maintenance: Keep the product clean and dry. Lubricate rollers if they become noisy or do not easily rotate.
/