2. Dish Network
  3. HDE-8C-QAM

Dish Network HDE-8C-QAM Quick Manual

  • Hello! I am an AI chatbot trained to assist you with the Dish Network HDE-8C-QAM Quick Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
• Connect the unit as pictured to the right:
• Locate the receiver labels numbered 1 through 9 in the plastic bag
supplied with the encoder.
• Find the receiver ID number label on the rst receiver. Write the last
4 digits of the ID on label #1 (RX1_####__) and place on the front of
the receiver.
• Repeat for all 9 satellite receivers (8 primary plus 1 optional spare).
• Now connect each receiver output to the encoder inputs, making
sure that receiver #1 (RX#1) is connected to #1 component input on
the encoder. Repeat this process for remaining receivers.
• Connect the Receivers Control 10/100 port on the encoder (see
section 2.2 #11 in manual) to an Ethernet switch (with a minimum of
10 ports) with a CAT 5 jumper cable.
• Connect the 9 satellite receivers to the same switch.
• Power up the receivers and the encoder.
• Log in to the HDE-8C-QAM, using a standard web browser. This can
be done through the Control 10/100 port, next to the Receiver
Control port. Either go directly from a computer or through an
Ethernet switch
• Assign 172.16.70.2 as the static address for your computer
• Now open your browser and enter 172.16.70.1 to access the
HDE-8C-QAM.
• The Username is “Admin” and the password is “pass”
STEP 2
HDE-8C-QAM QUICK GUIDE
STEP 1
IP=172.16.70.1
IP=172.16.70.2
Optional Spare
10/100
Ethernet
Document # 651235400A Stock # 6370-1
To download instrucon manual visit www.BlonderTongue.com | 800-523-6049
(For supported Dish Network Receivers)
• Setup the QAM output channels by going to the
Main > Output > QAM tab
• Select the channel for the 1st QAM. The next 3 will be
automatically assigned.
• Ensure all outputs are on and CW mode is not enabled.
• Click “SAVE” to apply changes.
STEP 3
• If not already, allow several minutes for the receivers to be
discovered and assigned IP addresses
• From the Main > Input Cong Tab of the Web Pages, assign
RX#1 to Input #1, RX#2 to Input #2, etc.
• Click “SAVE” to apply changes.
STEP 4
STEP 5
To download instrucon manual visit www.BlonderTongue.com | 800-523-6049
• Go to the Main > Output > TS Cong Tab
• Verify the Multiplexed MPTS Output default settings are suitable
for your application
- TS bitrate = QAM Modulator
-Modulation Mode = QAM 256
-Out of band = disabled
• Verify the Output Mapping Section.
- Input for each TS must be different.
- Every PID and Program Number must be different.
- Short Name should be a descriptive name of the
program, as it will be shown on the television
(max 7 alphanumeric characters)
-Major and Minor Channel numbers are what the
TV will display as the channel.
• Click “SAVE” to apply changes.
/