11 US-EN
Open the cover of the battery compartment 6 on
the back of the product.
If applicable, remove the used battery.
Insert a battery type CR2032 in the battery com-
partment 6.
Note: Make sure you insert the batteries with the
correct polarity. This is indicated on the cover of
the battery compartment 6.
Close the cover of the battery compartment 6
and tighten the screw 7.
1X3V CR2032
6
7
Use
Set the product on a solid, level and flat surface
to weigh.
Weighing
To activate the product, you can simply put a load
(e.g. included weighing bowl 1) and items
weighing at least 8.8 oz (250 g) onto the weigh-
ing platform 5. Or you can push down on the
weighing platform 5 with a certain amount of
force to activate the product. Press the TARE but-
ton 3 to reset the numerical display 8 to “0”.
Place the item you wish to weigh on the product’s
weighing platform 5. The numerical display 8
will show the weight of the item you are weighing.
Note: You only need to lightly press the TARE
button 3 and the UNIT button 4 to operate the
product. Excessive pressure may cause the prod-
uct to tip. During this time the weighing equipment
on the product is adjusting. Afterwards the numeri-
cal display 8 will read “0”. The unit display 9
will show the last unit selected.
Note: If the weighing bowl 1 was already on
the scale when it was switched on, only the weight
of the food is displayed. However, if you place the
weighing bowl 1 on the product after you have
switched it on, the product will indicate the weight
of weighing bowl 1. You can press the button
TARE 3 at any time to reset the numerical display
8 to “0”. The “Tare“ symbol 11 will appear.
Place the item you wish to weigh in the weighing
bowl 1. The numerical display 8 will show the
weight of the item you are weighing.
Incremental weighing
If any food is already in the weighing bowl 1,
the weight of the food and the bowl 1 will be
shown in the the numerical display 8.
Touching the TARE 3 button with the product on
will reset the numerical display 8 to “0”. The
“Tare” symbol 11 will appear.
Now add another item to weigh to the weighing
bowl 1. The numerical display 8 will show the
weight of the item you just added.
If you remove the item you added from the weigh-
ing bowl 1, the numerical display 8 will again
read “0”.