B-VENT TRANSITION COLLAR KIT - 8" CHIMNEY
[FOR USE WITH APPLIANCE MODELS RAPTURE36/42/50]
B-VENT TRANSITION COLLAR
8" CHIMNEY
P/N 127134-01
Rev. B, 03/2017
HEARTH PRODUCTS
KITS AND ACCESSORIES
Cat. No. Model Description
F0930 BTC-8 B-Vent Transition Collar Kit, 8"
GENERAL INFORMATION
Transition pipe, model BTC-8, is required for use with B-type
venting. The BTC-8 transition collar and starter collar are shown
in Figure 1.
READ ALL THE STEPS BEFORE STARTING THE INSTALLATION
THE APPLIANCE MUST BE OFF AND COLD BEFORE BEGINNING.
ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN THE
INSTALLATION AND OPERATION MANUAL PROVIDED WITH THE
APPLIANCE APPLY TO THESE INSTRUCTIONS.
If you encounter any problems, need clarifi cation of these instructions
or are not qualifi ed to properly install this kit, contact you local
distributor or dealer.
If any of these parts are missing or damaged, contact your dealer or
IHP.us.com for referral information.
KIT CONTENTS
4 ea. Screws, 10x1/2 HWH LGM AB Zinc
1 ea. Pipe, 8" B-Vent Transition
1 ea. Instruction Sheet
Figure 1 - B-Vent Transition Collar Kit
Printed in U.S.A. © 2014 Innovative Hearth Products
P/N 127134-01 Rev. B 03/2017
IHP reserves the right to make changes at any time, without notice, in design, materials, specifi cations, prices and also to discontinue colors, styles and products. Consult your local distributor for
fi replace code information.
IHP
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
IHP.us.com 1
INSTALLATION.
1. Remove starter collar and set aside.
2. Slide transition pipe over vent collar and attach with a minimum
of 4 screws.
3. Replace starter collar over transition pipe and attach using 4 screws
located on leg stands.
4. To install b-vent piping, slide fi rst piece of b-vent over transition
pipe and attach with either a minimum of 3 screws or other means
approved by the vent manufacturer.
B-Vent Piping
Transition Pipe
Model BTC-8
Starter Collar
Vent Collar