2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. OTC
  7. 6067

OTC 6067 Operating instructions

  • Hello! I've reviewed the Operating Instructions for the OTC 6067 Injector Remover/Installer Kit. This document provides a guide on how to remove and replace injectors on 7.3L DIT diesel engines using provided tools such as the forcing screw, block and replacer. I'm ready to answer your questions about this kit and its usage.
  • What type of engines is this kit designed for?
    In what type of vehicles this kit can be used?
    What parts are included in the kit?
    How is the injector removed?
    How is the injector replaced?
Form No. 106272
Operating Instructions
for: 6067
655 Eisenhower Drive
Owatonna, MN 55060 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7223
Fax: (507) 455-7063
Website: www.otctools.com
Ford
Injector Remover / Installer Kit
Application: 7.3L DIT diesel engines
used on 1994 & newer 3/4- and 1-ton
trucks, vans, & Super Duty trucks
Removing the Injector (Figure 1)
1. Place the block under the injector hold-down.
2. Thread the forcing screw through the top corner of
the injector hold-down, and draw the injector out
of the head.
Replacing the Injector (Figure 2)
1. Place the injector into the injector bore in the head.
2. Using the replacer and screw, seat the injector in
the head by tightening the screw into the valve
cover attaching screw hole.
Refer to the vehicle service manual for the complete
procedure.
Figure 1
Figure 2
Forcing Screw
Block
Replacer
Forcing Screw Block
Replacer
Screw &
Washer
CAUTION: To prevent
personal injury, wear eye
protection that meets ANSI
Z87.1 and OSHA standards.
Injector
Hold-Down
Sheet No. 1 of 1
Issue Date: Rev. B, May 4, 2016
© Bosch Automotive Service Solutions Inc.
/