2. Dime
  3. Embroidery Tool Shed Software

Dime Embroidery Tool Shed Software Installation guide

  • Hello! I've reviewed the user manual for installing the Embroidery Tool Shed (ETS) software on a Macintosh computer. The document provides a step-by-step guide through the download, installation, and launch procedures. I'm here to help you with any questions you might have about installing this software.
  • Where do I download the Embroidery Tool Shed (ETS)?
    What do I do if a 'Developer Cannot Be Verified' notification appears?
    How do I locate the Embroidery Tool Shed (ETS) icon after installation?
After installing the dimeTRANSLATOR, download the Embroidery Tool Shed
(ETS) from the Inspiration Software Download Center webpage at the link below.
https://www.inspiredbydime.com/inspiration-software-download-center/
When the download is complete, go to the DOWNLOADS folder on your computer.
Click once on the ETSSetup.exe to select it - it should appear highlighted.
Click ACTIONS from the top menu bar, then OPEN WITH from the drop-down menu.
Choose EMBROIDERY XPORT.
INSTALLING The eMBROIDeRY TOOL SheD
ON YOUR MACINTOSH COMPUTER
NOTE: A notication may pop up stating that the “Developer Cannot Be Veried”
If this happens click on “Cancel” and after a few moments the InstallShield Wizard will launch.
This launches the InstallShield Wizard for the Embroidery Tool Shed.
1 2
When the installation is complete click the “Launch Pad” icon at the
bottom of your screen to locate the Embroidery Tool Shed (ETS) icon.
Click Next. Click “I accept…” and click “Next”.
43
Click Install. Click Finish.
65
7
Because the Launch Pad does not list apps
alphabetically, check the last page by clicking on
the far right dot at the lower center of your screen.
Locate the ETS icon. Double-click the
icon to open your Embroidery Tool Shed
software.
TS
e
8
/