2. Eaton
  3. Smart Energy Manager app

Eaton Smart Energy Manager app Quick start guide

  • Hello! I'm your chat assistant. I've reviewed the quick start guide for the Eaton smart breaker and the Smart Energy Manager app. This document provides instructions for installing the breaker, setting up the app, and connecting the devices to your Wi-Fi. I'm ready to answer any questions you have about connecting your smart breaker.
  • How do I install the smart circuit breaker?
    How do I create an account?
    What do I do if the Network Status LED is not blinking?
    What should I do if the breaker does not connect to Wi-Fi?
Step 3
Create Home
Step 2
Download the app and create an account
Download the Smart Energy
Manager app on the Apple App
Store or Google Play Store.
Create an account and verify
it with an active email address.
Log in at the home page.
Step 1
Install Smart Circuit Breaker
Ensure that the smart circuit
breaker is installed into the
loadcenter and powered up.
Refer to the instructions in
the box or the installation
video. Always use a qualified
electrician to install and wire
the smart circuit breaker.
How to connect Eaton’s smart breaker
with the Smart Energy Manager app
Once account
registration is
successful. Select
‘Create Home’.
Create a name for
your Home.
Add your location. Select an icon.
How to connect Eaton’s smart breaker
with the Smart Energy Manager app
Quick Start Guide -
Smart Energy Manager app
Effective May 2022
Step 3
Create Home
Add a photo for
your Home.
Your Home has been
created successfully.
Step 4
Add new breaker
Select ‘ADD A NEW
BREAKER’.
Enter a name for
your breaker.
Select the loads for
this breaker (multiple
loads can be added).
Type in your
Wi-Fi credentials.
Step 5
Enable BlinkUp
On the Smart Breaker,
press the “DISPLAY”
button and ensure that
the Network Status
LED is blinking. If it is,
then touch the “NEXT”
button on your phone.
After reading the
instructions on the
phone, touch the
“NEXT” button.
After reading the
instructions on the
phone, touch the
“START BLINKUP”
button.
After reading the
Warning message,
touch “Continue
to BlinkUp”, then
place your phone’s
screen AGAINST the
Network Status LED
on the smart breaker
until your phone
vibrates and beeps.
Note: Do NOT look
at the screen during
BlinkUp. This should
take no more than
90 seconds. If your
device is already
blinking orange, it failed
to connect. Touch the
“CANCEL” button to
try to connect again.
How to connect Eaton’s smart breaker
with the Smart Energy Manager app
Once the BlinkUp
process is complete,
you will be notified
when the device is
successfully connected
to the Wi-Fi network.
You should now
see the device in
the Breakers tab.
Eaton is a registered trademark.
All other trademarks are property
of their respective owners.
Eaton
1000 Eaton Boulevard
Cleveland, OH 44122
United States
Eaton.com
© 2022 Eaton
All Rights Reserved
Printed in USA
Publication No. PA003027EN
May 2022
Quick Start Guide -
Smart Energy Manager app
Effective May 2022
Note: In the case your breaker does not connect,
review the troubleshooting information.
• Check you entered the correct Wi-Fi credentials
• Ensure your phone is touching the breaker during BlinkUp
• If problems persist contact BLsupport@eaton.com or
the Eaton Technical Resource Center at 1-877-ETN-CARE
(386-2273) option 2, option 9 for further assistance
/