2. Victron
  3. Filax 2 Ultra Fast AC Transfer Switch

Victron Filax 2 Ultra Fast AC Transfer Switch Installation guide

  • Hello! I've reviewed the user manual for the Filax 2 inverter. This document provides essential steps for installing the device, including instructions on removing links for low loads and setting the frequency jumper. I'm ready to answer your questions about the setup and configuration.
  • What should I do if the load is less than 850W?
    How do I set up the frequency for 50Hz?
    How do I set up the frequency for 60Hz?
Remove both links if the load is less than 850W
Frequency jumper:
• If the installation frequency is 50 Hz, remove the frequency jumper, or place it on only one of the pins (this is the default
setting).
• If the installation frequency is 60 Hz, place the jumper on both pins.
Jumper placed = 50Hz ........... Jumper not placed = 60Hz
Filax 2
Page 9 Installation
/