grips4Less Winn Wrap Operating instructions

I've reviewed the instructions for installing Winn Wrap Grips. These instructions specify the need to use the traditional method with grip tape and solvent, and they emphasize the importance of sliding the grip straight onto the shaft to avoid separation of the wraps. I'm ready to help with any questions you have.
What installation method should be used?

Can I use an air compressor for installation?

What should I do to ensure the grip goes on properly?

Special Instructions for Winn Wrap Grips

Important: All wrap style grips by Winn Grips need to be carefully installed. They must be

installed using the traditional method with grip tape + solvent (or mineral spirits). They cannot

be installed using the air compressor method.

Instructions:

1) Watch this video: http://www.winngrips.com/grip-replacement

2) Use plenty of solvent to lubricate the grip and shaft.

3) Slide the grip on straight onto the shaft. Any bending will cause the wraps to separate.

4) If you have any questions, please contact us at: [email protected]

Disclaimer: Winn will not replace improperly installed grips. Grips4less is not responsible for

improper installation.