Installation instructions for
HALO soap dispenser
Box Contents:
1 Dispenser
1 Opening Key
4 Fitting Screws and Plugs
Tools Required:
Drill
Screwdriver
1
Open the unit with the key provided.
2
Remove the reservoir and put
to a side for installation.
3
Mark out the holes for fixings.
4
Please see the pre-installed
spirit level to aid installation.
5
Drill the marked out holes
to the size of the fixings
provided then use a
screwdriver to fix the unit
to the wall. The unit should
be hand tight to the wall.
6
Reattach the reservoir and
fill it with the relevant product
to the pump supplied.
7
Prime the dispenser by pushing the button,
after a few pumps, the soap should start to
flow, and the unit is ready to be used.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Lotus Exige S/C Service Notes
-
B-Tech BT7553-050 Flat Screen Ceiling-Desk Mount Installation guide
-
Falcon Elan 90 Dual Fuel User manual
-
Rangemaster Toledo XT 110 Dual Fuel Users Manual & Installation
-
-
Falcon 1092 User's Manual & Installation And Servicing Instructions
-
-
-
-