2. D-Link
  3. DAP-1320
DAP-1320

D-Link DAP-1320 Installation And Setup Manual

  • Hello! I am an AI chatbot trained to assist you with the D-Link DAP-1320 Installation And Setup Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1
How do I setup and install my DAP-1320?
How do I setup and install my DAP-?
The DAP-1320 can be setup by two different methods:
1. Push button WPS (Wi-Fi Protected Setup)
2. Manual
Note: In order to setup the DAP-1320 using WPS, you must have a WPS compatible router/access
point
Push Button WPS
Step 1: Plug in the DAP-1320
Note: The light should turn red and then start blinking orange
Step 2: Press the WPS button on your router/AP
2
How do I setup and install my DAP-1320?
Step 3: Press and hold the WPS button on the DAP-1320 until it starts blinking green and then
release. Once connected, the LED will be solid GREEN.
3
How do I setup and install my DAP-1320?
Step 4: Unplug and place the DAP-1320 approx half way between the router and the desired con-
nection area.
Note: To connect wireless to the DAP-1320, use the Wi-Fi Network Name (SSID) and Wi-Fi Pass-
word information located on your configuration note.-á
Manual Setup
Step 1: Plug in the DAP-1320
Note: The light should turn red and then start blinking orange
4
How do I setup and install my DAP-1320?
Step 2: From a wireless computer/device, scan for available networks and connect to the pre-
defined SSID
(Located on the Companion Card supplied with the DAP-1320 and on the bottom of the DAP-1320)
example: Dlink-6DFC .
5
How do I setup and install my DAP-1320?
Step 3: Open a Web browser and type dlinkap.local.
You will be directed to the d-link setup page. Click next to start the setup.
Step 4: Select the Manual configuration method and click “Next”.
The DAP-1320 will scan for available wireless networks. Select the Wi-Fi network you would like the
DAP-1320 to extend and click “Connect”
Note: If the wireless network you are trying to extend is security enabled, you will be prompted for
the Wi-Fi password.
6
How do I setup and install my DAP-1320?
Step 5: Next you need to create a wireless network name and password for your extended net-
work. It is suggested to configure a name that is different from your "Primary" wireless network.
Click Next
Step 6: Confirm your wireless settings and click save
Setup is now complete. Once the DAP-1320 has applied its settings, its light should be Green and
you should be able to connect to the Extended Wi-Fi Network.
/