Rev.A
INST-785
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
STANDARD CF19
HARDWARE
MOUNT
CF20 BRACKET
BRACKET
BRACKET HARDWARE
INSTALLATION INSTRUCTIONS
7160-0972
Printing Spec:
Revision
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
CF20 UPGRADE KIT
PS-001
Product Form
HARLEY POLICE TOUR-PAK MOUNT -
© Copyright 2017 Gamber-Johnson, LLC
These installations instructions cover the replacement of a standard CF19 computer
mounting bracket with the CF20 bracket. The Gamber-Johnson Harley Police Tour-Pak
vehicle base (7160-0352) is required. The bracket mounting hardware is included if the
original hardware is missing. These instructions do not apply to the CF20 variant of the
vehicle base (7160-0352-01) that is shipped fully assembled with the bracket and base
ready to install. Refer to INST-539 for instructions on installing the vehicle base.
BASE
CF 20 BRACKET
1/4-20 X .875
BOLTS
BELLEVILLE WASHER
BELLEVILLE WASHER*
BELLEVILLE WASHER*
BELLEVILLE
WASHER*
1/4-20
NYLOCK NUT
NYLON WASHER
NYLON WASHERS
To Install the CF20 Bracket:
Remove the hardware holding the original CF19 bracket in the mount.1.
Install the new CF20 bracket in the mount reusing the original hardware or the 2.
hardware included in the hardware bag. See FIG 1 below.
*NOTE - Belleville washers should be installed with domed side facing outward.
FIG 1 - HARDWARE INSTALLATION (MIRRORED ON OPPOSITE SIDE)
-
1
-
2
Gamber-Johnson Harley-Davidson Police Tour-Pak Panasonic CF-20 Mount Upgrade Kit Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Gamber-Johnson 7160-0352-01 Installation guide
-
-
Gamber-Johnson 7160-1265-10 Installation guide
-
-
-
Gamber-Johnson 7300-0597-10 User guide
-
-
-
-
