Toilet Tank To Bowl Bolt
Model PF025 , PF035
Toilet Tank To Bowl Bolt
Modelos PF025 , PF035
Toilet Tank To Bowl Bolt
Modèles PF025 , PF035
1
You may need/Puede necesitar/Vous pourriez avoir besoin
CAP16/06 REV.A www.PROFLO.com
®
Adjustable Wrench Sponge
Head screwdriver
bucket
2CAP16/06 REV.A www.PROFLO.com
1. Turn off water supply. Flush toilet and remove excess water from tank
with sponge. Remove water supply line from bottom of toilet fill valve.
1
2. Unbolt tank from bowl, then lift off tank. Remove washers and nuts from
bottom of tank, then remove old bolts. Remove old gasket.
3. Slide new sponge rubber gasket (small side down) over nut on threaded
end of flush valve. Using diagram at right for reference, install bolts as
follows: Slide rubber washer under bolt head and insert bolt through tank.
Install brass washer, then thread hex nut onto bolt. Carefully tighten bolt
until snug.
4. Place tank back on bowl so that sponge gasket fits evenly.Using diagram,
install rubber washer, brass washer, then wing nut onto bolt. Repeat for
other side. Tighten nuts evenly.DO NOT OVERTIGHTEN or bowl may crack.
Reconnect water supply line to toilet tank fill valve. Turn on water supply.
BOLT
RUBBER WASHER
HEX NUT
WING NUT
TANK
BOWL
WASHER
RUBBER WASHER
WASHER
OPTIONAL
{
-
1
-
2
ProFlo PF035 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
American Standard ChinaLux 1000 RF User manual
-
Fluidmaster 6102 Installation guide
-
Glacier Bay N2316 User guide
-
-
-
-
-
-
Glacier Bay N2316-BLK Operating instructions
-