Pegasus 4011-PL-PB, 4011-PL-CP Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Pegasus 4011-PL-PB Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Tub Filler
with Diverter
ASSEMBLY INSTRUCTIONS
P 847•244•1234 www.barclayproducts.com
2/28/08
Carton 1 Contains: Valve Body #4073
Gooseneck Riser Pipe #196R
Tools Needed
Phillips Screwdriver Level 1/4” Drill Bit
Wrench Wood Screws Set Screw
Cat. No.
4011
Carton 2 Contains: Sunflower Shower Head #5590
Parts Needed
Wall Support Part #4195WS (Sold Seperately) •
1. Apply teflon tape to both ends of the hot and cold supply nipples on the valve body. Thread the large lock
nuts and metal washers onto the other ends of the nipples and secure the shower set to the tub.
2. Assemble shower head to gooseneck riser pipe. Also, assemble porcelein levers to the valve body.
HOT on left, COLD on right.
3. Slip the wall bracket over the straight end of the riser pipe. Carefully slide the bracket to the appropriate
position (approximately half-way up the rod) and tighten the set screw provided.
4. Assemble riser pipe to the riser coupling assembly on the spout by tightening the coupling nut. After hand
tightening, fasten securely by using a wrench.
5. Secure wall support bracket to the wall using the screws provided with part #4195WS.
/