AllPondSolutions AP-IS-KIT User manual

Brand
AllPondSolutions
Model
AP-IS-KIT
Type
User manual
AQUARIUM AIR
PUMP INSTRUCTION
MANUAL
AP-IS-KIT APO-KIT
O Connect your air pipe (4mm internal diameter) to the AP'S outlet(s)
O Place the AP above water level on a flat surface if possible
(this will reduce noise levels)
O Connect a non return valve between your air hose a few inches from
the AP (image 1)
O Position your air pipe in your aquarium with or without air
stone as required
O Plug in the AP
O Using the dial on the back Of the unit you can choose what speed
the pump operates at
• Regularly clean your air pipe and airstone (if in use) to ensure
maximum output and prolonged lifespan
• ALWAYS use a non-return valve on your AP's outlet(s) to ensure
water is not siphoned back into the AP
CONTENTS
AP-3-KIT
AP-I .5-KlT
• AP-I .5 Air Pump o
Air Stone x 1 0 Non-
return valve x 1 o
Air hose x 2m
0 AP-3 Air Pump
O Air Stone x 2 0
Non-return valve x 2
O Air hose x 4m
The pump comes complete with a generous supply of 3 core cable,
however, should any additional cable be required, then the use of an
approved waterproof cable connector is essential.
• The power supply must be earthed and fused at 3amp
• Regularly inspect the cable for damage and deterioration
• Consult a qualified electrician if in doubt about any aspects of
wiring
• DO not connect to any voltage Other than stated on pump
IMPORTANT! Disconnect mains electricity supply before attempting
installation, handling or maintenance.
• Never submerge the AP, it is designed to be run external to your fish tank
• Only for use in an aquarium environment
• Do not attempt to modify this unit in any way and only use the
recommended parts for replacement All connections must be earthed
• Do not connect to any voltage other than stated
• When installing your AP you must have a drip loop to avoid condensation
build up running up and down your power cable — please see (image 2)
for a detailed example of this
• If the unit fails, isolate completely from your aquarium and contact the
supplier
All Pond Solutions products are supplied with a warranty
guaranteeing parts in the event of a genuine fault or mechanical
failure for 12 months from date of purchase.
We do not accept liability for reasonable wear and tear, accidental
damage or problems arising from modification or misuse.
Spare parts are available at our official website or from your local
supplier. Please ensure that only genuine All Pond Solutions
components are used when completing a replacement or repair.
In the event Of product failure, not using the supplied non-return valve
may void your warranty.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

AllPondSolutions AP-IS-KIT User manual

Brand
AllPondSolutions
Model
AP-IS-KIT
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents