2. Advanced Wireless Communications
  3. Nurse Call Box

Advanced Wireless Communications Nurse Call Box Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the Advanced Wireless Communications Nurse Call Box Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Remove all 4 Screws
With a Phillips screwdriver and
remove the top piece.
If Adhered
To a foam piece, use an
object, such as a screwdriver,
to score along each side of the
battery, reducing the amount
of contact to the adhesive
surface. Then try to pull the
battery out again, repeat until
the battery is removed.
Once Removed
Flip the nurse call box top
over to expose the inner
workings. The battery is
located at the top.
To Remove Battery
Hold the nurse call box top still
while pulling on the battery.
If not easily removed the battery
might be adhered to a foam piece.
Recycle
The old battery at your local
recycling center.
Remove the Foam Piece
By carefully peeling it o.
If there is no piece of foam you may
skip this step.
500640
©2018 Advanced Wireless Communications. All rights reserved. *All other trademarks are the property of their respective owners.
(800) 475-5852
20809 Kensington Blvd, Lakeville, MN 55044
www.advancedwireless.com
Quick Start Guide
Nurse Call Box Battery Replacement
Please Note
An Alkaline AA Battery will Not Work
Even though the battery is similar in size to an alkaline AA battery it is a 3.6-volt Lithium battery.
Insert New Battery
A new Lithium battery will be
inserted in the same location
with the positive side facing
to the left. This is easy to
remember due to the plus
located above the battery slot.
Place the Piece of Foam
Horizontally right above the
raised surface in the center of
the call box bottom. Leave the
protective lm on the exposed
side of the foam.
A Piece of Thick Foam
Will need to be placed on the
nurse call box bottom piece to
help secure the battery.
If your call box already has a thick
piece of foam attached to the bottom
piece you may skip the following
steps with the red border.
On the Thick Foam Piece
Remove one side’s protective
lm to expose the adhesive.
Double Check
That the string assembly is
properly threaded before
replacing the Nurse Call Box
top.
Replace the Top
Onto the bottom section and
secure with the 4 screws.
500640
©2018 Advanced Wireless Communications. All rights reserved. *All other trademarks are the property of their respective owners.
(800) 475-5852
20809 Kensington Blvd, Lakeville, MN 55044
www.advancedwireless.com
Quick Start Guide
Nurse Call Box Battery Replacement Continued
/