Interlogix 1038 Series Installation guide

Brand: Interlogix

Model: 1038 Series

Type: Installation guide

1038-N

1038 Series

Surface Mount with Wire Leads

Gap Distance Closed Loop

1" 1038

Color

White, Mahogany Brown

Quantity

100% TESTED

GE Magnetic Contacts

UL Specifications

Part Loop Electrical Gap

Number Type Configuration Distance

1038 Closed N.O. 1"

Gap Specifications are nominal and may vary

20%. Gap Specifications are for switch to make.

Break distance is approximately 1.1 to 1.5 times make.

WARNING: Each electrical rating is an individual maximum and cannot be exceeded!

FORM A (1038)

Voltage: 100 V AC/DC max

Current: 0.5 A max

Power: 7.5 W max

1038 Series

Surface Mount with Wire Leads

Installation Instructions

1. Clean mounting surfaces with alcohol pad (included).

2. Align and attach mounting plates for the switch and magnet using tape or screws (included).

Wire may be routed on either end or through the top of the switch housing cutouts.

3. Strip loop wire and connect the leads to the alarm loop.

4. Place switch and magnet covers over the center of the mounting plates and slide either left or

right until the cover snaps in place.

1038696 Rev A 07/02

www.GE-InterlogixSecurity.com 2266 Second Street North

North St. Paul, MN 55109

Phone: 651-777-2690

USA & Canada: 800-777-5485

Technical Service: 800-777-2624

12345 SW Leveton Drive

Tualatin, OR 97062

Phone: 503-692-4052

USA & Canada: 800-547-2556

Technical Service: 800-648-7424

Faxback: 800-483-2495

GE Interlogix

2.26"

(5.74cm)

.38"

(0.95cm)

.40"

(1.00cm)

1.63"

(4.13cm)

Made in Taiwan

Interlogix 1038 Series Installation guide

Interlogix 1038 Series Installation guide

Interlogix 1038 Series Installation guide

Related papers

Other documents