2. Everbilt
  3. 63147

Everbilt 63147 Installation guide

  • Hello, I've reviewed the installation guide for the EVERBILT shower stem 1006965013. This document provides instructions on how to install the shower stem, covering steps from turning off the water to checking for leaks. I'm ready to assist you with any questions you have about the installation process or the components covered in this guide.
  • What tools are required for installation?
    What should I do before starting the installation?
    What should I use to protect the finish while removing the flange?
    What do I do after replacing the stem?
Installation Instructions:
1. Turn off water supply. Release pressure.
2. Remove handle button and handle screw. (Use handle puller if you have trouble removing your handle.)
3. Remove the flange. (Use masking tape to protect the finish.)
4. Remove the old stem using the socket wrench. (NOTE: If replacing the stem only, skip to step 6.)
5. Using a seat wrench, remove the old faucet seat and replace with the seat included.
6. Make sure cap stem gasket is in place, and thread new stem into faucet. Tighten with socket wrench. (Do not over tighten.)
7. Reinstall the flange.
8. Replace handle and button.
9. Turn on water and check for leaks.
SHOWER STEM
INSTALLATION INSTRUCTIONS 1006965013
Tools Required:
Screwdriver
Adjustable Wrench
Seat Wrench
Socket Wrench
Optional:
Handle Puller
Shower with Flange:
ButtonScrew
HandleFlange
Nipple
Stem
Bibb
Seat
Cap
Gasket
Shower with Sleeve and Flange:
Bibb
Seat
Cap
Gasket ButtonScrew
Handle
Sleeve
Flange
Stem
/