2. FLEXCO
  3. Electric Belt Cutter Drill

FLEXCO Electric Belt Cutter Drill Operating instructions

  • Hello! I'm your chat assistant and I've reviewed the provided document which is a set of instructions for replacing the drill in a FLEXCO belt cutter model X2145. These instructions cover important steps like disassembling the old drill, mounting the new one, aligning couplings, and securing all parts. I am here to answer any questions you have about the process or the device.
  • What type of hex key is needed to disassemble the drill?
    Which way do you turn the left-handed screw to remove it?
    In which direction the left-handed screw should be tightened?
    What should you verify before installing the final screws?
    What is recommended to be used to secure the coupling to the drill?
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 • USA
Tel: (630) 971-0150 • Fax: (630) 971-1180 • E-mail: info@flexco.com
Visit www.flexco.com for other Flexco locations and products.
©2009 Flexible Steel Lacing Company. 04-23-20. For Reorder: X2145
DANGER
!
• Do Not Use in Explosive Atmosphere
• Do Not Operate Without Guards
X2145
Electric Belt Cutter
Replacement Drill Instructions
1. Unplug drill from power source.
Disassemble drill from housing by
removing three screws (4 mm hex key).
2. Remove le- handed screw that attaches
the coupling to the housing by turning it in a
clockwise direction.
3. Disassemble female coupling from old
drill by unscrewing from the drill sha.
4. Screw female coupling onto new drill sha. 5. Secure coupling to drill by applying
Loctite®, inserting le-handed screw, and
tightening it in a counter-clockwise direction.
6. Make sure coupling and black rubber
“spider” (part of original unit) are placed
in the housing and that the key and keyway
are engaged.
7. Insert drill into housing, be sure to
align the couplings. For proper coupling
engagement, there should be no space
between the housing neck and drill
casing. Verify that the drill is working and
the blade is rotating before installing the
nalscrews.
8. Align drill vertically with the housing. 9. Lock the drill in place by applying
Loctite to the three screws and installing
until tight.
/