2. Enwork
  3. eBench™

Enwork eBench™ Installation guide

  • Hello! I'm a chat assistant that has read the Installation Guide for eBench EI0011. This document includes a parts list, tool requirements, and a detailed step-by-step guide for assembling the End Panel. I'm ready to answer any questions you might have related to the installation process.
  • What type of screws are used to attach the End Panel to legs?
    What bracket is used for installation?
    What type of screw is used to secure bracket?
EI0011 – eBench End Panel Installation Guide – Rev A
eBENCH END PANEL
INSTALLATION GUIDE
BENCHING
E I0011
INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
2) TOOLS AND SUPPLIES REQUIRED
End Base
#10x 1” Panhead Screw
Power Drill
End Panel EBM-1335 Bracket
10-24x 2” Phillips Bolt
#2 Square Bit Phillips Bit
INSTALLATION GUIDE
Take the End Panel and slide it between the
Legs. Use the 2” Phillips screws to attach the
two together.
Remove the levelers from the bottom of the legs.
Place the EBM-1335 bracket into the leveler hole
and secure with the provided #10 screw.
Reinstall the leveler and repeat until all End Panels
have been installed.
FIGURE 1
FIGURE 2
FIGURE 3
3) ASSEMBLY:
Specications subject to change without notice.
Rev 04.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331
/