GB-4 GB-5
SAFETY FIRST!
For your continued safety and to reduce the risk of injury or electric shock, please
follow all the safety precautions listed below.
• Read all the instructions carefully before using this appliance and keep them for
future reference.
• Retain the manual. If you pass the appliance on to a third party, make sure to include
this manual.
• Unplug the appliance from the mains socket when not in use, or before cleaning any
part of the appliance.
• Allow the appliance to completely cool down before cleaning.
• Never immerse the appliance in water and always keep the electrical contacts dry.
• Never place the appliance on or near a source of heat such as a cooker ring or gas
ame.
• Always place the appliance on a dry, at and stable surface.
• Avoid contact with the steam from the appliance’s spout. Take care when pouring or
relling after boiling.
• To prevent boiling dry, do not ll the appliance with water less than the minimum ll
level as indicated on the appliance.
• Use the appliance to heat only water.
• Do not interfere with the normal working of the switch.
• Always keep the appliance out of the reach of small children. Children should be
taught about the dangers of boiling water.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instructions concerning the use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• If the mains cable is damaged it must be replaced by the manufacturer, its service
agent, or similarly qualied persons in order to avoid a hazard.
• Do not let the mains cable hang over the edge of the work surface or allow it to
touch hot surfaces or sources of heat or ame.
• This appliance is intended to be used in households and similar places such as:
- Sta kitchen areas in shops, oces and other work places.
- By clients in motels, hotels and Bed & Breakfast establishments.
DSG Retail Ltd • Maylands Avenue • Hemel Hempstead
Herts • HP2 7TG • England
Visit Partmaster.co.uk today for the easiest way to buy
electrical spares and accessories. With over 1 million
spares and accessories available we can deliver direct to
your door the very next day. Visit www.partmaster.co.uk or call 0844 800 3456 (UK
customers only). Calls charged at National Rate.
This symbol on the product or in the instructions means that your
electrical and electronic equipment should be disposed at the end of its
life separately from your household waste. There are separate collection
systems for recycling in the EU. For more information, please contact the
local authority or your retailer where you purchased the product.
(P.N. L17KPS12-003)
Stainless Steel Kettle
Instruction Manual
L17KPS12
Thank you for purchasing your new Logik Kettle.
We recommend that you spend some time reading this instruction
manual in order to fully understand all the operational features it
offers.
Read all the safety instructions carefully before use and keep this
instruction manual for future reference.
SPECIFICATIONS
Mains supply: 220-240V~50Hz
Power consumption: 1850-2200W
We continually strive to improve our products. Specications may change without
prior notice.
Replacement Part Part Number
NOTE: If you require a replacement for any of the items listed below, please
quote their corresponding part numbers:
Kettle Stand L17KPS12-005
Scale Filter L17KPS12-006
Ensure the kettle is cool before removing the lter.
CLEANING THE REMOVABLE SCALE FILTER
To prevent loose particles of limescale being poured into your beverage, your
kettle is tted with a scale lter. You may remove the lter and t it back in after
cleaning.
1. To remove the lter, open the lid.
2. Push out rmly on the inside of the
lter, lift up and remove.
3. To t the lter, open the lid.
4. Place the lter inside the spout,
ensuring the bottom hook rests in its
match inside the spout.
5. Push down on the lip of the lter. It
will click into place.
90˚
90˚
C
M
Y
CM
MY
CY
CMY
K
L17KPS12_IB_RC_final120731_BW.pdf 1 31/7/12 3:51 PM
GB-1 GB-2 GB-3
UNPACKING
Remove all packaging from the unit. Retain the packaging. If you dispose of it
please do so according to local regulations.
The following items are included:
SWITCHING ON
• Place the kettle on its stand. Connect the stand’s mains cable to the mains socket.
FIRST TIME USE
Clean your kettle by boiling a full kettle of water twice and then discarding the
water.
PRODUCT OVERVIEW
• The Main Unit
Lid
Handle
• Instruction Manual
(P.N.: L17KPS12-003)
• Kettle Stand
(P.N.: L17KPS12-005)
Spout
• Never open the lid while the
water is boiling. The steam
coming out from the kettle is
very hot.
• If there is insufficient water in
the kettle, the automatic
safety cut-out will operate. If
this happens, allow the kettle
to cool for 10 minutes before
relling with cold water and
re-boiling.
Power Connector Hole
Indicator
Mains
Cable
Kettle
Stand
Power
Switch
Open
Button
FILLING THE KETTLE
• Push the Open Button down. The lid will spring open to 90˚.
• Fill the kettle with the required amount of water.
• Do not exceed the maximum ll level (MAX. 1.7L) as
indicated by the “MAX” mark on the interior of the
kettle.
• Always ensure the kettle is lled passed the
minimum ll level (MIN 0.9L) as indicated by the
“MIN” mark on the interior of the kettle.
• Gently push the lid closed. It will click shut to
indicate it is fully and securely closed.
If the kettle is overfilled, boiling water
may be ejected from the spout and cause
scalding.
90˚
• Pull the power switch up to the ON
position.
WHEN THE WATER HAS BOILED
The kettle will automatically switch off.
CLEANING THE KETTLE
The kettle exterior should be cleaned with a soft damp cloth. Do not use abrasive
cleaners or scouring pads which may damage the nish of the kettle.
Never immerse the kettle or the stand in water and always keep the electrical
contacts and the power connector hole dry. Always disconnect from the mains
before cleaning the stand.
DESCALING THE KETTLE
Depending on the hardness of the water in
your area, limescale may be deposited on
the heating element and the inside of the
kettle. This normal build-up is not harmful
to health but an excessive amount of scale
may affect the performance of the kettle.
To descale, ll the kettle with distilled water
up to three-quarters of the Max level and
bring the water to boil. After the kettle has
switched off, add a descaling solution
following the manufacturers instructions.
Never attempt to descale the kettle by
chipping or scraping with a sharp
implement.
• Ensure that the switch is not obstructed and the lid is rmly closed.
The kettle will not turn off if the switch is obstructed or if the lid is
open.
• After removing the kettle, there may be some water on the surface of
the stand. This is condensation from the steam that causes the kettle
to automatically switch off after boiling. This is normal and should not
be a cause for alarm.
• The indicator on the side of kettle will
light up blue to indicate that the kettle
is heating.
90˚
Stainless Steel Kettle
Instruction Manual
L17KPS12
Thank you for purchasing your new Logik Kettle.
We recommend that you spend some time reading this instruction
manual in order to fully understand all the operational features it
offers.
Read all the safety instructions carefully before use and keep this
instruction manual for future reference.
ON
OFF
ON
OFF
ON
OFF
C
M
Y
CM
MY
CY
CMY
K
L17KPS12_IB_RC_final120731_BW.pdf 2 31/7/12 3:51 PM
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Hitachi KET5BA User manual
-
Currys Essentials C17JKW11 User manual
-
-
-
Mellerware 62200W User manual
-
-
Avancer AVSSQTKKVAA User manual
-
-
Currys Essentials C17JKW17 User manual
-
