1
SAFETY PRECAUTIONS
Please read before using
The lightning ash with arrowhead symbol, within an equilateral triangle, is intended
to alert the user to the presence of insulated dangerous voltage within the product’s
enclosure that may be sucient magnitude to constute risk of electrical shock.
The exclamaon point within an equilateral triangle is intended to alert the user to
the presence of important operaon and maintenance (servicing) instrucons in the
literature accompanying the appliance.
FCC STATEMENT
WARNING
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following
two condions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received including interference
that may cause undesired operaon.
* Federal Communicaons Commission (FCC) Statement
WARNING
This Equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protecon
against harmful interference in a residenal installaon. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instrucons,
may cause harmful interference to radio communicaons. However, there is no guarantee that
interference will not occur in a parcular installaon. If this equipment does cause harmful
interference to radio or television recepon, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separaon between the equipment and receiver.
— Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
* You are cauoned that changes or modicaons not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
• Users should not aempt to disassemble the camera. There are no user serviceable parts
inside. Ask qualied service personnel for servicing.
• Do not use strong solvents or detergents. Use a dry cloth on the camera when it is dirty.
• Before operang, please check proper temperature, humidity and power source rangs.
• Do not aim the camera at bright objects or place it in direct sunlight. This may result in
blooming or smearing.