6. Put sufficient quantity of cold water into your coffee maker according Max.300ML
7. Place the appliance onto the power base unit, and switch on the coffee maker by
simply pressing on/off switch
8. At this time mix your coffee for one or two times using stainless steel measuring and
mixing spoon
9. When the coffee starts bloating out, turn off the appliance and pour a little coffee into
the cups (for foam)
10. Replace your appliance onto the power base unit and restart the coffee maker, then
pour the coffee to the cup when the prepared coffee bloats out again.
11. You can prepare coffee in different measures according to your personal taste.
12. An automatic safety cut-out has been fitted for protection against running dry. If you
do not put in enough water, or switch on when it is empty, the safety cut-out will switch
off the power automatically. If this happens, wait a few minutes for the element to cool,
then refill and use as normal.
13. Appliances are not intended to be operated by means of an external timer or
separate remote-control system.
14. Place the power base on a dry, flat surface. Place the coffee maker on the power
base. The electrical connection will be made automatically as the coffee maker slides
onto the power base.
15. Plug the cord set into an earthed power socket and switch on by depressing the
switch of the coffee maker to the “ON” position.
16. After allowing the coffee maker to cool down for 15 – 20 seconds, the water can be
brought back to the boil by pushing the switch back to the “ON” position. During the
cooling down time do not force the on/off switch into the “ON” position as this can
damage the operating mechanism.
17. Do not remove the coffee maker from the power base without switching off first.
18. Remember, if you do not wish to re-boil the coffee, switch it off.
19. The coffee maker may be switched off manually at any time by setting the on/off
switch into the “OFF” position.