Modern Forms

www.modernforms.com

Phone (800) 526.2588 • Fax (800) 526.2585

Headquarters/Eastern Distribution Center

44 Harbor Park Drive • Port Washington, NY 11050

Phone (516) 515.5000 • Fax (516) 515.5050

Western Distribution Center

1750 Archibald Ave • Ontario, CA 91761

Phone (800) 526.2588 • Fax (800) 526.2585

Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. 2

PREPARATION

1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.

2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.

MOUNTING THE FIXTURE (Fig. 1)

3. Remove the mounting screw (C) from the mounting back plate.

4. Secure the mounting back plate to the junction box using junction box screws (B). The side of the mounting back plate marked “GND”

must face out.

CONNECTING THE WIRES (Fig. 2)

5. Connect the xture’s wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A) are secured. If your outlet

INSTALLATION INSTRUCTION

258 – LED Wall Sconce

WS-25816/ WS-25816F

C

Wire Connector

Junction Box Screw

Mounting Plate

House Wires

Green or Bare Copper

(Ground)

Fig. 2 Wiring

FIG 1.

4”

1 3/4”

1 3/8”

14 7/8”