Important Safety Notice
Please read the below safety instructions carefully before
installation and operation.
1. Please follow all warnings and guide lines before installation
and operation.
2. Do not expose the device to rain, moisture or liquid
3. Do not modify, open or attempt to repair the device
on your own
4. Keep the device in a ventilated area to avoid overheating.
5. Power down the HDMI source and Display before connecting
the adapters
Introduction
The Diamond VS50 HDMI to HDMI small form factor wireless
transmitter and receiver is designed to eliminate the ugly HDMI
cable from your video source to your HD wall mounted TV. Both
the sender and receiver are powered via USB port which are
readily available on your televisions and video sources such as
set top boxes, Blu-ray/DVD players and Gaming Consoles.
Slim small formfactor allows provides portability for business use
as well. The transmitter can be connected to a laptop while the
receiver can be connected to a conference room display or
projector, great for presentations and collaboration applications.
Features
• Support HDMI1.3, compatible with HDCP1.2.
• Maximum resolution up to 1080p full HD.
• 5GHz operation frequency
• Supports point to point wireless configuration.
• 30ft transmission range
• Plug and play, easy installation. No drivers. No configuration needed.
Package Contents
• VS50 (Transmitter) x 1
• VS50 (Receiver) x1
• USB Type A to Micro power cable x 2
• HDMI extension cable x 2
• RT angle HDMI to HDMI converter x 1
Connector/LED Indicator Connection Diagram
Installation Requirements
1. HDMI source component (Set top box, DVD/Blu-ray, PC or
Game Console and any device with HDMI output).
2. HDMI display/projector
3. USB port for power. Note: If you do not have an available
USB port on the source or the display you can use a stand
USB wall mount charger with the included USB power cables
1. HDMI Output:Connect directly to the HDMI display or Projector
2. Wireless Status: flashes slowly when paired to the receiver.
and flashes rapidly when video/audio is being transmitted.
3. Power Input: Connect to the USB port of the display/projector.
4. Power Indicator: Remains on when powered.
Sender
Receiver
1. HDMI Input:Connect directly to your HDMI source you want to
send from.
2. Wireless Status: Remains on when the HDMI input is detected,
flashes slowly when paired to the receiver and flashes rapidly
when video/audio is being transmitted.
3. Power Input: Connect to the USB port of the source, example if
you are using a PC you may power the sender from the PC’s USB port.
4. Power Indicator: Remains on when the device is powered.
Note: This device can be powered from the HDMI port directly
without the need for the external power option. However, if you
experience any instability with connection or poor audio quality,
you will have to use the external Micro USB power connection.
1. Connect the HDMI wireless sender directly to the HDMI output of
the source. Note: use the included HDMI extension cable if
needed.
2. Connect the HDMI wireless receiver directly to the HDMI input of
the display/projector. Note: if needed use the HDMI extension
cable.
3. Connect the USB Micro cable to the power input of the receiver
and then connect the other end to the USB port on the
display/Projector. If your display/projector does not have a USB
port you can use a standard USB wall charging adapter
(Not Included).
4. Once connect with in a few seconds you should be connected
and transmitting video wirelessly from your source to the display.
Note:
• Transmitting through walls, glass or other obstacles will signal
loss. For best performance place the sender and the receiver
in the same room with a clear line of sight.