Installation Instructions for
Tae Linear Suspension
980TAESP
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing
NEC compliant junction boxes.
This product is suitable for damp locations.
Incandescent lamps may be dimmed with a standard incandescent
dimmer. LED lamps may be dimmed with a LED dimmer. Consult
lamp manufacturer for additional information.
1.0
S 1078, S 1079UU
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Suspension
1
Remove the fixture screws located on the sides of the canopy using the provided Allen Wrench, then remove the mounting plate from the
canopy.
Temporarily install the mounting plate onto the electrical box with the two #8-32 screws provided.
Mark the location of the drywall anchors. Then remove the mounting plate.
Tap the drywall anchors into the drywall at the marked locations.
Reinstall the mounting plate and screw the anchor screws into place.
Adjust the height (Optional): Shorten the cords to the desired length by loosening the strain relief and pulling the cords into the canopy.
Trim excess cord left in the canopy.
Adjust the rings (Optional): Adjust the ring(s) height by loosening the cord grip on all cords. Slide the ring(s) to the desired location then
re-tighten the cord grips.
Connect the fixture to suitable ground in accordance with local electrical codes.
Connect the white fixture wires to the neutral power line wire with a wire nut.
Connect the black fixture wires to the hot power line wire with a wire nut.
Properly place all wires and wire nut connections into the canopy, mount the fixture back onto the mounting plate, and reinstall fixture
screws (reversal of step 1).
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage information.
2
SAVETHESE INSTRUCTIONS!
1
© 2018 Lighting.All rights reserved.The " Lighting" graphic is aLBL LBL
registered trademark of Lighting. Lighting reserves the right toLBL LBL
change specifications for product improvements without notification.
7400 Linder Ave, Skokie, 60077IL
800.323.3226 - 847.626.6300
www.lbllighting.com
A Generation Brands Company
1
2
1A
Install the Fixture
3
4
5
6
7
ANCHOR SCREW
LAMP
MOUNTING PLATE
RING
CORD
SOCKET
8
9
6
9
ANCHOR
#8-32 SCREW
10
11
12
FIXTURE SCREW
ALLEN WRENCH
CORD GRIP
7
10
9
8
5
4
1
12
/
