(Not Included)
E-commerce Division - Enitial Lab
Page 1 of 20
18-07-11
FGI-1867C12
FGI-1867C25
Page 2 of 20
Page 3 of 20
Page 4 of 20
Page 5 of 20
Page 6 of 20
Shoe Cabinet
MODEL #FGI-1867C25
MODEL #FGI-1867C12
Get Ready
Please group boards as below
Page 7 of 20
Page 08 of 20
Apply a dab of glue to dowel holes
before inserting dowels (#3).
Flip to other side.
Page 09 of 20
Spring assisted
Non-spring assisted
Refer to page 5 on how to secure cam
locks (#2) to cam bolts (#1).
Page 10 of 20
Finished Side
Page 11 of 20
Finished Side
Page 12 of 20
Page 13 of 20
Finished Side.
Page 14 of 20
Thin line gap towards the bottom of panel (#C).
Page 15 of 20
Make sure the holes of pole (#14) are all facing upwards in this step.
Page 16 of 20
Add a slider (#26) in-between back panels (#P,Q).
Thin line gap towards bottom of panel (#D).
Page 17 of 20
Attach shelf pins (#5) to the desired
height of the shelves (#H,G).
Page 18 of 20
Insert non-spring assisted pin (#11) into the hole of the
unit first before the spring assisted pin (#12).
Page 19 of 20
Insert fixative plates (#10) throughout the
grooves of the back panels, then secure
by using screws (#9).
Page 20 of 20
/
