Gamber-Johnson DS-57 Installation guide

Category
Car kits
Type
Installation guide

This manual is also suitable for

Rev.A
INST-15
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
INSTALLATION INSTRUCTIONS
Form Product Revision
DS-57
Printing Spec:
PS-001
Flat Floor Base
1. If it is desired to cover the bottom of the base with the carpet or floor mat, lay the material
back to expose the bare floor.
2. Place the base in the passenger footwell with the post in the corner closet to the hump
and the seat. Move the base around until the best post location is determined. Mark the
mounting hole locations, and note whether it will be necessary to shim any corner with
washers to compensate for floor irregularities.
3. Drill 1- 13/32" hole at each mounting hole location, using care not to damage any
equipment below the floor. Most bases have holes for 3/8" bolts, but holes for 1/2" bolts are
furnished in the taller bases.
4. Place bolts, washers and nuts in all holes, shimming as necessary with fender washers,
and tighten. Do not use lag screws or sheet metal screws as these can pull out of the floor.
5. The height is adjustable by loosening the bolt at the top of the post one turn. If necessary,
tap lightly on the top of the bolt to release the top plate. Adjust the height and direction
of the top plate and retighten the bolt.
adjust top plate height.
Loosen and tap bolt to
Base sits flat on the floor
in the passenger footwell
up against the hump.
© Copyright 2013 Gamber-Johnson, LLC
  • Page 1 1

Gamber-Johnson DS-57 Installation guide

Category
Car kits
Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI