Stovax Reflex 105 Multi-Sided Operating instructions

Stovax
Brand
Stovax
Model
Reflex 105 Multi-Sided
Type
Operating instructions
Reflex
Multi-Sided Inset Convector Fire Range
3 to 2 Sided Conversion kit
IMPORTANT
THE OUTER CASING, FRONT AND GLASS PANEL BECOME EXTREMELY HOT DURING OPERATION AND WILL RESULT IN
SERIOUS INJURY AND BURNS IF TOUCHED. IT IS THEREFORE RECOMMENDED THAT A FIREGUARD COMPLYING WITH BS
8423 (LATEST EDITION) IS USED IN THE PRESENCE OF YOUNG CHILDREN, THE ELDERLY OR INFIRM.
This product contains a Heat resistant glass panel. This panel should be checked during Installation and at each servicing interval. If any damage is observed on
the front face of the glass panel (scratches, scores, cracks or other surface defects), the glass panel must be replaced and the appliance must not be used until a
replacement is installed. Under no circumstances should the appliance be used if any damage is observed, the glass panel is removed or broken.
It is essential that ALL of the screws that retain the glass frame are replaced and tightened correctly. Under no circumstances should the appliance be operated if any of
these screws are loose or missing.
These Instructions must be left with the appliance for future reference and for consultation when servicing the appliance. Please make the customer aware of the
correct operation of the appliance before leaving these instructions with them.
The commissioning sheet found on Page 3 of this Instruction manual must be completed by the Installer prior to leaving the premises.
PR2885.1.12.2020
2
KIT CONTENTS
Decorative Panel
Brackets x 2
Inner
Panel x 1
Decorative
Panel x 1
Inner Lining
Panel x 1
CONVERTING FROM 3 TO 2 SIDES
Remove the decorative base and side trims.
1
2
Loose the front glass clamps.
Top Pivot Brackets
Bottom Pivot Brackets
3
4
Top Support Bracket
Bottom Support Bracket
Gap
Gap
5
3
Lift out the front glass.
6
1
2
Loosen and slide side glass bracket.
1
2
7
Repeat for the 2 upper Brackets and 2 lower Brackets.
62
Upper Side Brackets
Lower Side Brackets
8
With the brackets disengaged, carefully slide the side glass panel
forward, lift, and swing the bottom out to remove.
Place the glass carefully to one side.
1.
2.
3.
9
Fully remove the side bracket.
10
Remove the side clips.
10
Fit the side panel.
11
Attach the top and bottom side brackets.
12
Fit the decorative trim.
13
Slide in the side liner.
1.
2.
3.
14
Ret the front glass.
15
Ret one of the decorative side trims and new base trim.
16
Gazco Ltd, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JG
Tel: (01392) 474011 Fax: (01392) 219932 E-mail: [email protected] www.gazco.com
E & O E
*PRPR2854*
PR2854
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Stovax Reflex 105 Multi-Sided Operating instructions

Stovax
Brand
Stovax
Model
Reflex 105 Multi-Sided
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents