Kärcher BDS 43/150 C Operating instructions

Brand: Kärcher

Model: BDS 43/150 C

Type: Operating instructions

QUICKSTART

5.964-047.0 06/12

Warning

These are only brief instructions! Please read and comply with these instructions prior to using or servicing your

appliance.

The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers

for the operator and other persons.

Start up

1A B Danger

Risk of injury. Pull the plug from the mains

before carrying out any tasks on the appliance.

A Pull the lever for level adjustment and

bring the handle toward the front into a

vertical position.

Tilt the appliance rearward.

B Place the disc brush/driver plate onto the

actuator and turn in anti-clockwise direction.

Set up the appliance.

2A B Detergent tank (option)

A Remove the lid.

Insert the filling hose into the fill opening

and guide the other end to a water faucet.

Fill in fresh water (maximum 50 °C).

B Fill detergent solution into the detergent

tank. Replace the lid.

3ABCA Insert the mains plug into a socket.

B Pull the lever for level adjustment.

C Tilt the handle into a comfortable position

(arms outstretched).

Hold the handle with both hands.

Release the lever for level adjustment.

Operation

1AStarting the machine

A Press and hold the unlocking button.

Use the ON/OFF switch.

Release the unlocking button.

Caution

Risk of damage to the floor covering.

Do not operate the appliance on the spot.

2AControl the direction

ALeft: Press the handle downward.

Right: Raise the handle.

BDS 43/150 C

QUICKSTART

5.964-047.0 06/12

3ACleaning

A Apply the detergent solution to the floor or

use the dosing lever of the detergent tank

(option).

Move the appliance over the surface to be

cleaned.

Repeat process for severe contamination.

Afterwards, pick up the wastewater with a

wet vacuum or a cloth.

Finish operation

Turn off the appliance

A Release the handle switch.

B Pull the lever for level adjustment and

bring the handle in a vertical position.

C Disconnect the mains plug from the

socket.

D Wind the mains cable around the cable

holders.

Swivel the top cable hook upward.

2AEmpty and clean the detergent tank

(option)

몇Warning

Please observe the local provisions regarding the

wastewater treatment.

A Remove the detergent tank (option) and

dispose of unused detergent solution.

Rinse the detergent tank (option) with

clear water.

3ATurn off device

A Pull the lever for level adjustment and

bring the handle toward the front into a

vertical position.

Tilt the appliance rearward.

Remove the driver plate / disc brush.

Operation

QUICKSTART

5.964-047.0 06/12

Maintenance and care

daily

monthly

Kärcher Customer Service

1AA Check brush for wear and tear and

clean it.

Check the brushes for wear (bristle

length at least 10 mm), replace if

required.

Rinse contaminated disc brushes

with water.

Wash contaminated pads at a max.

temperature of 60 °C.

2AA Check the mains connection cable

for damages.

3AA Clean the casing with a damp cloth.

Troubleshooting

1AInsufficient cleaning result

A Check brush for wear and tear and clean it.

Check the brushes for wear and replace if

necessary; replace the brush if the bristles

are shorter than 10mm.

–Replace contaminated pads and wash them

at a max. temperature of 60 °C.

–Rinse contaminated disc brushes with water

–Check the suitability of brush/pad and deter-

gent for the respective use.

2A B Appliance vibrates strongly

A Check for correct seating of disc brush/pad.

Check pad attachment.

B Position the handle lower (arms out-

stretched).

3APad does not turn

A Check if foreign bodies are blocking the

brush/pad; remove the foreign bodies if

required.

Kärcher BDS 43/150 C Operating instructions

Kärcher BDS 43/150 C Operating instructions

Kärcher BDS 43/150 C Operating instructions

Related papers

Other documents