Vermont Catalytic Performance Pack Operating instructions

Brand
Vermont
Model
Catalytic Performance Pack
Type
Operating instructions
18390-005_R1 • 02/20
Catalytic Performance Pack - Instructions
Model: Dauntless
Tools Required
• Gloves
• Drill Gun
• 1/4” Nut Driver
Install the Ceramic Catalyst
1. Locate the access cover positioned at the rear center of
the unit, Figure 1.
2. Remove the access cover by pulling straight up and out,
Figure 2.
3. Install the catalyst by gently placing it into the cavity and
straight down, Figure 3. Place the catalyst where the
catalyst’s ceramic components will not be damaged.
Figure 1 - Locate access cover.
Access Cover
Remove
Access Cover
Figure 2 - Remove access cover.
Install Catalyst
Figure 3 - Install catalyst.
Install the Catalyst Temperature Probe
1. Install the catalyst temperature probe by removing the
knockout located at the back left hand side of the unit,
Figure 4.
2. Once knockout is removed, drill a hole using the 3/16”
Drill bit supplied in the dimple located just behind the air
jacket.
3. Install thermostat duct, bracket and temperature probe
using (2) #8 Tek screws also supplied in the kit.
4. Lastly, make sure to fold the bracket strap over catalyst
probe and secure with remaining screw.
Figure 4 - Install the Catalyst Temperature Probe
Thermostat Bracket
Thermostat Duct
Catalyst Probe
Catalyst Probe Installed
Fold bracket strap over
catalyst probe shaft and
secure with screw.
Kit Includes
• Ceramic Catalyst
• Temperature Probe & Bracket
• 3/16” Drill Bit
• (3) #8 Tek Screws
  • Page 1 1

Vermont Catalytic Performance Pack Operating instructions

Brand
Vermont
Model
Catalytic Performance Pack
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents