Dakota Digital RTX-69C-CAM Mounting Manual
- Category
- Wall & ceiling mounts accessories
- Type
- Mounting Manual
Manual # 650653
RTX-69C-CAM
Dakota Digital RTX Instrument Installation
For 1969 Chevrolet Camaro
Your new RTX-69C-CAM kit includes:
Installation
Control Box
Main Harness
Universal Sender
Pack
Installation Manuals
RTX Displays
Buzzer
1. Remove the clear lenses, light bulbs, indicator light panels, and gauge internals; they are held into
the housing with nuts from the backside. You may be able to access all of the fasteners with the
dash carrier installed; removing the entire assembly may not be necessary.
Interconnect
Harness
Foam Tape
2X 10-32x1” Mounting Screws w/
nylon washers
2X 10-32x1.5” Mounting Screws w/
nylon shoulder washers
Switch
Assembly
Manual # 650653
3. Connect one end of the interconnect
harness to the new RTX speed gauge
as well as the Buzzer (optional for
audio feedback).
Buzzer Connector
2. For each gauge opening, cut three pieces of the
supplied foam tape, 2” long. Install foam strips on
the top and sides of each opening about ½” down
from the face of the housing. This foam provides
a cushion where the new RTX cans are installed
and forms a tight, rattle-free fit.
4. Route the other ends of the interconnect harness and the Buzzer through the large opening
shown below. Using the two provided 10-32 x 1.5” screws and nylon shoulder washers,
secure the speedometer assembly to the housing. Start the screws into the back of the factory
housing and into the pull-block on the back of the gauge assembly. Tighten with a 1/8” Allen
wrench.
Cable routed through
indicator light opening
Foam tape
Manual # 650653
7. Re-install the cluster into the vehicle and refer to the main manual for wiring instructions to
complete the RTX installation.
5. To install the tachometer, route the appropriate end of the interconnect harness back through the
housing indicator light opening on the tachometer side of the housing and connect to the back of
the tachometer gauge. Use the two 10-32 x 1” screws and two flat nylon washers to secure the
gauge
6. Connect the main harness to the
interconnect harness and route
cable to the control box.
-
1
-
2
-
3
-
4
Dakota Digital RTX-69C-CAM Mounting Manual
- Category
- Wall & ceiling mounts accessories
- Type
- Mounting Manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Dakota Digital RTX-77C-CAP Mounting Manual
-
Dakota Digital RTX-70C-CAM Mounting Manual
-
-
-
-
-
-
-
Dakota Digital Retrotech RTX-33F Installation guide
-