ESAB Linde Photocell Tracers are a versatile and precise tool for cutting shapes from metal. They use a photocell to follow a template, allowing for accurate and repeatable cuts.

Capabilities:

• Cut a wide variety of shapes from metal
• Follow complex templates
• Make precise cuts with a kerf width of 0.020-0.040 inches
• Cut at speeds up to 120 inches per minute
• Jump over gaps in the template and continue cutting on the other side

Use Cases:

• Creating one-off parts or small batches of parts
• Cutting intricate shapes that would be difficult or impossible to cut by hand
• Cutting shapes from thin metal sheets