Minka Group 8766-66-L User manual

Minka Group
Brand
Minka Group
Model
8766-66-L
Type
User manual
INSTALLATION INSTRUCTIONS
For Model 8766-L
READ AND SAVE THESE INSTRUCTIONS
WARNI N G! SH UT PO WER OFF AT F US E O R C I RC UIT BREAKE R.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
Fig. 2
Fig.3
L
K
P(Graphite sheet)
Q(LED module)
I (Module ring)
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove the old fixture.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Take care not to lose any small parts necessary for installation.
3. Carefully remove screws (B) to separate top cover (A) from fixture
body (C).
CONNECTING THE WIRES (Fig. 2)
4. While supporting the fixture, connect the electrical wires as
shown in figure 2. If your post has a ground wire (green or
bare copper), connect the fixture ground wire to it. If not,
consult your electrician for proper grounding. After the wires
are connected, tuck them carefully inside the post (E).
COMPLETING THE INSTALLATION (Fig.1)
5. Align the fixture (C) to post (E), and secure with mounting screws (D).
6. Align center glass (Z) onto heat sink (O). Re-attach top cover (A) to
fixture body (C) with screws (B).
7. Bulb (G) information: (1 x AC LED 10W included.)
DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE
PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified electrician
without cutting of wire and without damage to any decorative
element to which the fixture is attached. See installation steps for
more details (Fig 3.)
a. Carefully remove screws (B) to separate fixture body (C)
from top cover (A) (Fig.1). Remove glass (Z). Next remove
aluminum plate (O) from fixture body (C) by loosening screws
(K).
b. Remove wire nuts (L) hex-nuts (N) washers (M) and carefully
remove the LED module (Q). Note: The LED module should
be provided by a specified supplier.
c. For better heat dissipation the LED module (Q) should be
installed with the heat transfer material (P) when re-lamping
Your installation is now complete. Return power to the
junction box and test the fixture
FIXTURE
WIRES
Black or
Smooth
HOUS
E
WIRES
Black
(Hot)
HOUS
E
WIRES
White
(Neutra
l)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUS
E
WIRES
Green
or
Bare
Copper
(Groun
d)
  • Page 1 1

Minka Group 8766-66-L User manual

Minka Group
Brand
Minka Group
Model
8766-66-L
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents