George Kovacs P963-077 User manual

Brand
George Kovacs
Model
P963-077
Type
User manual

George Kovacs P963-077 is a modern and stylish light fixture that is perfect for any home. With its adjustable height and easy installation, it is the perfect way to add a touch of elegance to any room.

The P963-077 is made of high-quality materials and features a sleek, modern design. It is available in a variety of finishes, so you can find the perfect one to match your home's décor.

The P963-077 is also easy to install. It comes with all the necessary hardware, and the instructions are clear and easy to follow. You can have this light fixture up and running in no time.

George Kovacs P963-077 is a modern and stylish light fixture that is perfect for any home. With its adjustable height and easy installation, it is the perfect way to add a touch of elegance to any room.

The P963-077 is made of high-quality materials and features a sleek, modern design. It is available in a variety of finishes, so you can find the perfect one to match your home's décor.

The P963-077 is also easy to install. It comes with all the necessary hardware, and the instructions are clear and easy to follow. You can have this light fixture up and running in no time.

INSTALLATION INSTRUCTIONS
Item#P963-077 (New. 11/22/2012)
READ AND SAVE THESE INSTRUCTIONS
WARNING ! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
ASSEMBLING THE FIXTURE (Fig. 1)
1. Shut off power at the circuit breaker and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Determine the desired hanging height and if necessary,
cut the cord leaving an additional 5” to allow for
electrical connection.
4. Install the strain relief bushing (F) by removing screw (J)
from bushing (I) and pushing the cord through the
center of bushing (I) and strain relief (N) until about 5” of
the cord is exposed.
5. Secure the cord into strain relief (N) and bushing (I) by
tightening screw (J). The fixture may now hang from the
strain relief (N).
6. Carefully cut and remove approximately 4” of the outer
sheathing from the cord and strip 1/2” of the wire ends
bare to expose the copper strands.
7. Position the mounting plate (B) on the ceiling, and mark
the location of the three drywall anchors (D). Pre-drill the
holes for the drywall anchors (D) and insert the drywall
anchors (D) into the wall.
8. Attach the mounting plate (B) to the outlet box (A) with
mounting screws (C) (size: #8-32N*L0.5”).The side of
the mounting plate marked “GND” must face out.
9. Place the woodscrews (E) through the mounting plate
and into the drywall anchors (D) to secure the Mounting
Plate (B) to the ceiling.
CONNECTING THE WIRES (Fig. 2)
10. At this point, connect the electrical wires as shown in
Fig. 2, making sure that all wire connectors are secured.
If your outlet has a ground wire (green or bare copper),
connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the Mounting
Plate (B) using the green screw provided.
COMPLETING THE INSTALLATION (Fig. 1)
11. Place canopy (G) over mounting plate (B) and secure
with screws (H).
12. Align the holes on the metal Frame (L) and Glass
shade (M) to socket Cup (N), then secure them
with studs (K).
13. Install the light bulbs (not included) in accordance
with the fixture specifications. (DO NOT EXCEED
THE MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
Your installation is now complete. Return power to the
outlet box and test the fixture.
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-2232E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
D
C
E
F
A
N
K
L
M
B
G
H
I
J
  • Page 1 1

George Kovacs P963-077 User manual

Brand
George Kovacs
Model
P963-077
Type
User manual

George Kovacs P963-077 is a modern and stylish light fixture that is perfect for any home. With its adjustable height and easy installation, it is the perfect way to add a touch of elegance to any room.

The P963-077 is made of high-quality materials and features a sleek, modern design. It is available in a variety of finishes, so you can find the perfect one to match your home's décor.

The P963-077 is also easy to install. It comes with all the necessary hardware, and the instructions are clear and easy to follow. You can have this light fixture up and running in no time.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents