Flex Training Tables
Assembly Instructions:
Tools Required:
Phillips screwdriver
Glide wrench (included)
Before you begin, please make sure all parts and proper quantities are
included. Any parts damaged during shipment must be reported within
15 days of receipt. To report information regarding damages or if you
have any questions, please call 1-800-235-1262.
Table Assembly
To purchase parts or accessories, please contact us at
www.spectrumfurniture.com
1-800-235-1262
Thank you for choosing Spectrum products!
(1) 025069
Glide wrench
(2) 037749
Unit-to-unit brackets
(4) 0103920
1/4-20 x 1/2" Thumbscrews
37250 - 48" Round
37251 - 24"D Half-Round
37252 - 30"D Half-Round
37250
48" Round Table
37252
30"D Half-Round
37251
24"D Half-Round
(16) 026064
1/4-20 x 5/8" PHMS
(3) 037779
5/16-18 Glide
(16) 026064
1/4-20 x 5/8" PHMS
(4) 037779
5/16-18 Glide
37250 - 48" Round Table 37251 - 24"D Half-Round Table
37252 - 30"D Half-Round Table
.
ace wor
sur
ace
ace-
own on
o a non-a
ras
ve sur
ace.
B. Attach the legs to the work surface using 1/4-20 x 5/8" PHM screws
and tighten securely. Figure 1.
C. Attach the glides to the legs. Tighten securely with glide wrench.
D. Carefully flip the table upright-this may require two people.
Figure 2
Unit-to-unit
brackets
Attach legs with
1/4-20 x 5/8"
PHM screws
Glides
Connecting Half-Round Tables
A. Arrange the tables side-to-side in the preferred location.
B. Attach the unit-to-unit brackets to both table work surfaces as shown
with 1/4-20 x 5/8" PHM screws and tighten securely. Figure 2.
Note: For stability reasons, half-round tables are designed to be
connected to adjacent tables and are not recommended for stand-alone
use. If a more temporary arrangement is preferred, the easily removable
1/4-20 thumbscrews can be used on the unit-to-unit brackets instead of
Phillips screws.
Figure 1
Half-Round Table
Standard Tables
0106685X Page 1 of 1