dynarex Locking Raised Toilet Seat Operating instructions

  • Hello! I've reviewed the user manual for the Dynarex Raised Toilet Seat models 10360 and 10361. This document provides instructions for installation, cleaning, and safe usage of the raised toilet seat, including information about armrest installation for model 10360. I am ready to answer your questions about these products.
  • What should I do if the raised seat hits the toilet lid?
    How should I clean the raised toilet seat?
    Can I use the arm supports for full body weight support?
Manufactured for:
Dynarex Corporation
10 Glenshaw Street
Orangeburg, NY 10962
USA • www.dynarex.com
Made in China
R180222
Reorder Nos. 10360
10361
WARNING
Read the following instructions and make
sure you understand them. For clarification of
any step, consult a healthcare professional.
Improper installation and incorrect user
positioning on the raised seat could lead to
personal injury.
To avoid personal injury and damage to the
product, the user's weight must be distributed
evenly on the riser so that it will not move.
Supervision or assistance when using the
raised toilet seat is recommended for users
with limited physical capabilities.
Use the arm supports only for assistance. Do
not use the arm supports to support your full
body weight.
CARE
Clean with basic cleaning products and warm
water; rinse and dry. Do not use abrasive or
organic solvent products such as scouring pads,
acetone, lacquer thinner, turpentine or lighter
fluid as they may damage the commode.
INSTALLATION INSTRUCTIONS
1. Remove the raised toilet seat and any
components from package, making sure
it has not been damaged during handling
and shipping.
2. Lift the seat and lid of the toilet. If the top
rear of the raised toilet seat hits the existing
toilet seat or lid, you must remove the
existing toilet seat and lid for proper fit.
3. Turn the adjustment knob counterclockwise
to loosen the adjustment bracket. This will
allow the raised toilet seat to fit onto the
toilet bowl.
4. Place the raised toilet onto the bowl rim.
Ensure the rear flange is inside the edge
of the bowl. Check that the unit sits flat on
bowl rim. The knob must be at the front
end of toilet bowl.
5. Center the raised toilet seat on the bowl
rim and push it back as far as possible with
your hands.
6. Turn the adjustment knob clockwise to
tighten. Turn until resistance is felt, then
turn an additional 1/8 inch turn until secure.
Turn only by hand – do not use a wrench.
7. For 10360 – Insert armrest into the
designated openings in the toilet seat
frame, making sure push pins protrude all
the way through the adjustment holes.
Raised Toilet Seat
/