GENMAX GM6000iE User manual

USER MANUAL

FOR MODELS:

GM6000iE/GM6000iED

Portable Inverter Generator

5250(GAS.)/4750(LPG) Running Watts | 6000(GAS.)/5500(LPG) Peak Watts

R

2

CHONGQING DINKING POWER MACHINERY CO., LTD

GM6000iE 5250 6000 3.5 3600 312 80×62 0.21 10W30

(Gal)

A5RTC

(Gal)

GM6000iED 5250(GAS.)

4750(LPG)

6000(GAS.)

5500(LPG) 3.8 3600 312 80×62 0.21 10W30A5RTC

3

LIMITED WARRANTY

Model Number: _____________________________________

Name: ___________________________________________

Serial Number: ______________________________________

Street Address: ___________________________________

Date Purchased: ____________________________________

Purchased From: ____________________________________

City, State, ZIP: ____________________________________

Country: __________________________________________

Phone Number: ___________________________________

E-Mail: ___________________________________________

WARRANTY CARD

1.

R

Email: [email protected] Phone: 866-960-2920

4

LIMITED WARRANTY

Warranty Card

GENMAX Generator

11

12

13

14

15

16

17

18

19

20

21

22

23

22

SCHEMATICS 24

Generator

5

Connection of the product to a building’s electrical

system is not applicable.

6

generator

generator.

generator

7

SAFETY LABELS AND DECALS

6

generator

8

BASIC GENERATOR FEATURES

3

7

Fuel Cap: Open the fuel tank cap and fill with

proper amount of gasoline.

9

GM6000iE

10

11

AC Breaker:

to block current.

3RV30

3

Multifunction Digital Display Meter: Yellow light

means that the amount of oil is too low, red light

means that the machine overload, green light

means normal operation; Power display on the

left, oil level display on the right; Rolling display

mode, respectively display accumulative running

time, output voltage, frequency rolling display

mode.

Circuit Breake: A circuit breaker interrupts the

current when the whole circuit is overloaded.

AC 120V NEUTRAL FLOATING AC 120V NEUTRAL FLOATING

AC BREAKER

CIRCUIT BREAKER

ON

OFF

AC 120V/240V

NEUTRAL FLOATING

AC RESETCO ALARM ECO.SW.

DC 5V 1A/2.1A

SYSTEM FLOATING

11

2

10

4

CO Alarm LED: Flashing red light: dangerous levels

of carbon monoxide gas have built up leave

immediately until area has aired out. Move generator

to well-ventilated area before operation. Flashing

yellow light: carbon monoxide sensor malfunction.

Sensor needs service.

Engine Switch: Switch to ON to turn ON the fuel,

then hold down to start the generator.

generator

generator.

generator

generator.

10

GM6000iED

10

11

Multifunctional LED Digital Display Meter: Red

light (LOW OIL) means that the amount of oil is

too low, red light (OVERLOAD) means that the

machine overload, green light (POWER) means

normal operation. LED Digital Display shows

time, voltage, power, frequency and oil level;

Time: scrolling display of single running time and

accumulated running time; voltage: scrolling

display of 120V and 240V.

Main Breake: A circuit breaker interrupts the current

when the whole circuit is overloaded.

CO Alarm LED: Flashing red light: dangerous levels

of carbon monoxide gas have built up leave

immediately until area has aired out. Move generator

to well-ventilated area before operation. Flashing

yellow light: carbon monoxide sensor malfunction.

Sensor needs service.

4

2

11

10

12

Main SW.: Manage battery power and shutdown.

AC Protector: If the generator is overload, the AC

protector will trip to block current.

One Push Start: Press this button, the engine

can start and stop.

12

120-Volt/240-Volt, 30-Amp Outlet (NEMA L14-30):

The outlet is capable of carrying a maximum of 30

amps.

generator

generator.

11

GENMAX

Carbon Monoxide Speciﬁcation

CO DETECT technology monitors the accumulation of

carbon monoxide (CO), a poisonous gas produced by

engine exhaust when the generator is running. If CO

Sensor detects unsafe elevated levels of CO gas, it

automatically shuts off the engine. CO Sensor is not a

substitute for an indoor carbon monoxide alarm or for

safe operation. DO NOT allow engine exhaust fumes to

enter a conﬁned area through windows, doors, vents or

other openings. Generators must ALWAYS be used

outdoors, far away from occupied buildings with engine

exhaust pointed away from people and buildings. Meets

the requirements of ANSI/PGMA G300-2018.

GENERATOR

GENERATOR,

generator

Generator

generator

12

GENMAX

generator

GENERATOR

generator

generators’

generator

generator.

13

generator

14

generator

15

Hand Starter

1. Remove all the loads out of the output;

2. Turn the four-in-one switch to “CHOKE START”;

3. (see Figure 6)Then quickly pull the starting handle ;

4. After the generator starts, turn the four-in-one

switch to “RUN” and the generator can be used

normally with load.

NOTICE: Turning the four-in-one switch to “CHOKE

START” and pressing the red button for more than

5 s will damage the starting motor. If startup fails,

release the switch and wait 10 seconds before

restarting.

If the speed of the starter motor drops rapidly after

a period of time, it means that the battery should be

recharged.

1. Remove all the loads out of the output;

2. Turn the four-in-one switch to “CHOKE START” and

press the red button for 3-5 s before releasing the

generator;

3. Then turn the four-in-one switch to “RUN” and the

generator can be used normally with load.

Electric starting

Figure 6

WARNING: When the generator is started in warm

state, there is no need to turn the four-in-one switch

to “CHOKE START”.

Dual Fuel

1. Press the main switch to "ON". The start button will

light up for 2-3 seconds and then go off;

2. Switch the oil/gas switch to GAS. (or LPG);

3. Press the start button after the generator starts, the

generator runs normally;

4. After the generator starts, turn the four-in-one

switch to “RUN” and the generator can be used

normally with load.

Tip: The generator needs to switch from fuel oil to

gas state (or gas to fuel oil state) during normal

operation. The generator must be directly turned to

fuel oil or gas gear under no-load state to load and

use normally.

Procedure For Connecting Gas Pipes

1. Connect the dedicated gas hose to the generator;

2. Switch the oil/gas switch to the GAS. switch;

3. Press the start button after the generator starts, the

generator runs normally;

4. Open the air valve on the fuel tank and start the

generator according to the normal start-up steps.

GENERATOR

GENERATOR,

generator,

generator

16

1. Remove all loads in the output;

2. Turn the four-in-one switch to “OFF”, and the

generator stops running.

(see Figure 7).

Figure 7

AC 120V NEUTRAL FLOATING AC 120V NEUTRAL FLOATING

AC BREAKER

CIRCUIT BREAKER

ON

OFF

AC 120V/240V

NEUTRAL FLOATING

AC RESETCO ALARM ECO.SW.

DC 5V 1A/2.1A

SYSTEM FLOATING

GENERATOR

generator:

generator

generator.

generator

generator.

17

GENERATOR

generator

18

Figure 8

Figure 8.

generator

19

(see Figure 9).

Figure 9

Figure 10

(see Figure 11).

Figure 11

Air Cleaner Element

Air Cleaner Cover

Clip

generator

20

(see Figure 12).

Figure 12

(see Figure 13).

Figure 13

(see Figure 14)

Figure 14

generator

Page is loading ...

GENMAX GM6000iE User manual

Related papers

Other documents