Simpli Home AXCHUN-09 Assembly Instructions

Type
Assembly Instructions
MODEL # AXCHUN-09
Tall Bookcase
Hunter / Moreno / Diaz
7
Model # AXCHUN-09
TOP PANEL
QTY 1
SHELF
QTY 3
DRAWER FRAME
QTY 1
LEG
QTY 4
LEFT PANEL
QTY 1
RIGHT PANEL
QTY 1
ALLEN KEY BOLT
M6 x 25 mm
QTY 24
WASHER
Ø18 x 7 x 2 mm
QTY 44
ALLEN KEY
4 mm
QTY 1
FURNITURE TIP OVER RESTRAINT
QTY - 2 SETS
ALLEN KEY BOLT
M6 x 15 mm
QTY 20
8
A
D
D
D
E
F F
C
B
Model # AXCHUN-09
9
E
E
Model # AXCHUN-09
1. Place Drawer Frame E on a flat, smooth surface and remove drawer by pressing clip.
Press Clip, to
remove
drawer
from centre
rail
10
C
3
1
4
A
Step 2
Model # AXCHUN-09
1. Align holes on Top Panel A and Right Panel C .
2. Attach Right Panel C to Top Panel A using Allen Key Bolts 1 and Washers 3 .
3. Use Allen Key 4 to tighten.
11
Step 3
3
3
1
2
4
4
C
D
E
Model # AXCHUN-09
1. Align holes on Shelf D and Drawer Frame E with holes on Right Panel C .
2. Attach Shelf D and Drawer Frame E to Right Panel C using Allen Key Bolts 1 , 2 and
Washers 3 .
3. Use Allen Key 4 to tighten.
12
Step 4
3
2
4
F
B
Model # AXCHUN-09
1. Align holes on Leg F with holes on Drawer Frame E .
2. Attach Leg F to Drawer Frame E using Allen Key Bolts 2 and Washers 3 .
3. Use Allen Key 4 to tighten
4. Repeat steps 2 and 3 to attach Left Panel B .
13
Step 5
Model # AXCHUN-09
1. Insert the drawer into the Drawer Frame.
14
Step 6
Model # AXCHUN-09
Step 7
Furniture Tip Over Restraint Assembly
NOTE: The screwdriver is not
included in the hardware pack.
WARNING
If the furniture p over restraint kit is not in the box, please contact our customer
service department in order to obtain another kit before using the furniture.
Serious or fatal crushing injuries can occur from furniture p-over.
5
5
15
16
Furniture Anti-Tipping Restraint Instructions
1. Attach one of the mounting brackets securely to the back edge o f the furniture.
Use the shorter screw.
2. Determine where Furniture is to be placed and mark location o n the wall for mounting
bracket screw hole approximately 2 inches
below the bracket mounted to the furniture.
3. Drill a 3/16 inch hole in the wall. Press the plastic anchor into t h e hole and gently tap until the
flange on the anchor is against the wall surface.
4. Position the bracket over the anchor and use the longer screw t o securely attach the bracket
to the wall.
5. Place the furniture so the back edge is in line with the bracket o n t he wall.
6. Lace an end of the nylon zip-tie strap down through each bracket.
B r ing both ends together and slide the smooth side upright through the square-shaped
end and pull through to create the
“locked" position.
7. Check to make sure the strap is securely laced and locked to th e brackets.
DO NOT place heavy objects in top drawers or on top shelves
DO NOT put a TV or other heavy objects on top of furniture not intended for use with a TV
DO NOT let children climb or hang on drawers, doors or shelves
X
X
X
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16

Simpli Home AXCHUN-09 Assembly Instructions

Type
Assembly Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI