Skope ActiveCore Freezer User manual
- Category
- Fridge-freezers
- Type
- User manual
Skope ActiveCore Freezer
The ActiveCore Freezer is a high-performance refrigeration unit designed for demanding commercial use. With its advanced features and robust construction, it offers reliable and efficient temperature control for a wide range of perishable products.
Key Capabilities:
- Precise Temperature Control: Factory-set for storing perishable products at -18°C or below, ensuring optimal preservation and food safety.
- Adjustable Shelves: Customizable shelf heights allow for flexible storage arrangements to accommodate various product sizes.
- Internal Airflow Optimization: Designed to maintain consistent temperature distribution throughout the cabinet, preventing product spoilage due to uneven cooling.
Skope ActiveCore Freezer
The ActiveCore Freezer is a high-performance refrigeration unit designed for demanding commercial use. With its advanced features and robust construction, it offers reliable and efficient temperature control for a wide range of perishable products.
Key Capabilities:
- Precise Temperature Control: Factory-set for storing perishable products at -18°C or below, ensuring optimal preservation and food safety.
- Adjustable Shelves: Customizable shelf heights allow for flexible storage arrangements to accommodate various product sizes.
- Internal Airflow Optimization: Designed to maintain consistent temperature distribution throughout the cabinet, preventing product spoilage due to uneven cooling.
Page 1 of 4PRN80226 Rev. 1.1 Sep. 2022
RefrigerationRefrigeration
Freezer
User Guide – ActiveCore Freezer
Thank you for purchasing a SKOPE refrigeration product.
Safety
Always observe safety precautions when using any electrical appliance. Read these instructions carefully and retain them for
future reference.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
• Do not use this appliance for other than its intended use.
• Do not insert fingers/foreign objects into any holes.
• Only use this appliance with the voltage specified on the cabinet rating label.
• Ensure the appliance has adequate ventilation as this is essential to economical, high performance.
• Be careful not to touch moving parts and hot surfaces.
• For your own safety and that of others, ensure that all electrical work is done by authorised personnel.
• If the power supply flexible cord becomes damaged, it must be replaced by an authorised service agent or similarly qualified
person in order to avoid a hazard.
• If installing or removing the refrigeration unit, refer to the Installation Guidelines below, and observe all necessary safety
precautions.
• The appliance is not designed to be stable while in motion. Use extreme caution when moving or transporting it.
• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• If the cabinet is to be scrapped, ensure the cabinet is unplugged from the power supply and cut off the mains flex close to the
back of the cabinet. Be mindful of the risk of animals or children becoming trapped in the appliance – either remove or secure
doors if necessary.
• Refrigerant must be removed by a qualified service person and the cabinet recycled/disposed of in accordance with local
regulations.
Service & Support
We know you will get years of satisfaction from your new SKOPE product when you follow a few simple preventative maintenance
guidelines. Helpful information is available on the SKOPE website.
www.skope.com/serviceandsupport
WARNING
• Ensure the appliance is disconnected from the power supply before performing any cleaning or maintenance.
• Do not cover the grilles or block the entry or exhaust of airflow by placing objects up against the refrigeration unit.
• Should manual defrosting be necessary, turn off the refrigeration system and allow the ice to melt by air circulation. Collect
ice and water during defrost to prevent a slip hazard. Do not use mechanical methods to remove ice, as this may damage
the refrigeration circuit.
• Do not use any electrical devices or appliances inside the food storage compartment.
WARNING
•
Ensure the doors are held shut when moving or transporting the freezer.
This cabinet is designed to operate within a specific climatic class
environment.
See the cabinet rating label inside the cabinet for climate class number.
The cabinet includes relevant hazard symbols that may be associated
with the freezer. Refer to the information below for symbol description.
Climate class Ambient temperature Relative humidity WARNING
The refrigeration system contains flammable
R290 refrigerant. Do not tamper with it.
The refrigeration system must only be serviced
by qualified personnel.
3 25°C 60%
4 30°C 55%
5 40°C 40%
7 (tropical) 35°C 75%
Page 2 of 4 PRN80226 Rev. 1.1 Sep. 2022
RefrigerationRefrigeration
Freezer
Installation Guidelines
Ensure you consider and meet the installation guidelines.
If refrigeration cartridges must be removed (e.g. to transport the cabinet through a low clearance doorway), refer to
the Unit Removal Instructions on the back of the cabinet. Contact SKOPE if they are missing.
Ventilation Requirements
This freezer must have the following ventilation clearances at all times.
In certain climatic conditions, condensation may form on the back of the cabinet. If this is observed, ensure air circulation
between cabinet and wall by adhering two of the enclosed self-adhesive blocks to the cabinet back as shown.
Ventilation
Ensure all ventilation
requirements below
are met.
Door Opening
Allow adequate space
for the door/s to open
and close properly.
Sunlight
Do not install the
freezer in direct
sunlight.
Uneven Surface
Do not install the
freezer on an uneven
surface.
Surface
The installation
surface must be
capable of supporting
the loaded cabinet.
Power Supply
Do not overload the
power supply.
Blocking Ventilation
Do not store boxes or
items in front or on top
of the freezer.
Climate Class
The freezer must be
installed in an environment
within its climate class.
Rating Label
The climate class is stated
on the cabinet rating label
inside the freezer.
No below clearance required
Min. 300 mm above*
No behind
clearance
required
Vented top sign*
Min. 300 mm above*
No side
clearance
required
Rear top sign*
50mm
Adhesive Blocks
If required use two adhesive blocks on the rear of the cabinet. Position
the blocks on the left and right hand sides of the cabinet, approximately
in the centre and 50 mm from the cabinet edge.
Page 3 of 4PRN80226 Rev. 1.1 Sep. 2022
RefrigerationRefrigeration
Freezer
Door Handles
The door handles may be packed inside the cabinet.
Shelves
The wire shelves sit on shelf clips which twist onto the shelf support strips inside the cabinet. The shelves may be positioned at
different heights to suit various product. Use the numbers on the shelf support strips to help set the shelf clips at the same height.
Loading Product
Let the freezer run for 30 minutes before loading it with product for the first time. When loading the shelves with product :
Door Lock/s
The cabinet may be fitted with bracket locks or key locks, located above or below each door. Bracket locks require a lock (padlock
or similar) through the brackets to lock the door. Key locks can be locked with the supplied key.
To fit a door handle To remove a door handle
1. A metal spring is fitted inside the
handle mounts. Ensure the
springs point up.
1. Peel back the door gasket from
behind the handle mounts on the
inside of the door frame.
2. Unscrew the handle mounts
through the holes on the inside of
the door frame, and remove the
handle.
3. Only unscrew the top and bottom
screws. Do NOT unscrew the
middle screw.
2. Place BOTH handle mounts
simultaneously onto both door
brackets. Then push the handle
down onto the brackets until the
handle locks in place.
4. Remove the bracket/s from the
handle mount by pressing the
bracket in and down until it
unclips from the handle mount.
Troubleshooting
• If the handle doesn’t lock into
place, check that the spring clips
are pointing up and try again.
• If only one end of the handle locks
into place, remove the door
handle and refit with both handle
mounts located onto the brackets.
5. Fit and screw the bracket/s back
onto the door. Ensure the catches
are pointing up as pictured.
6. Clip the gasket back into place on
the inside of the door frame. If the
gasket is out of shape, use a hair
drier to heat and reshape it.
To fit a shelf clip
Twist anticlockwise
onto the shelf support
strip.
To remove a shelf clip
Pull the centre tab up
and twist off clockwise.
To adjust the shelf clip height
Pull the centre tab up, and
slide up or down as required.
Once in position, ensure it
clicks into place.
Handle
Bracket
Front of
door
Bracket
Spring clip
(pointing up)
Bracket
Handle mount
Handle
Bracket
Catch
Catch
Shelf Loading
Do not overload the
shelves.
Shelf Flexing
Remove product if the
shelf is flexing.
Shelf Overhang
Do not let product
overhang the shelves.
Front
Top
Back
MAX
46kg
per shelf
Internal Airflow
Leave 25 mm space
between product and
the back of cabinet
interior.
Cabinet Floor
Do not load product on
the cabinet floor. Use
the shelves.
Load Limit
Do not load product
above the load limit
indicators on the cabinet
interior sides.
LOAD LIMIT
Page 4 of 4 PRN80226 Rev. 1.1 Sep. 2022
RefrigerationRefrigeration
Freezer
Electronic Controller
The electronic controller regulates the cabinet’s temperature, signals alarms and captures
operational information. The temperature is factory-set for storing perishable product (all
shelves maintain
L1 temperature range: less than -18°C (can spike up to -15°C
).
To customise the settings to your requirements and view historical data, download the
SKOPE-connect app from the Google Play Store or Apple App Store, and connect via
Bluetooth®.
Lights
The lights switch on and off automatically, depending on cabinet use.
Cleaning
Note: the TMF1500N and SKFT1500N cabinets have two refrigeration cartridges.
Ensure the cabinet is unplugged from the power supply before cleaning.
Wipe the inside and outside of the cabinet with a damp cloth, taking care to keep moisture away from electrical parts.
The condenser coil must be kept clean. SKOPE strongly urges cleaning the condenser coil every three months.
Do NOT use hard or sharp tools to clean the coil as these may cause damage.
Clean the Coil
1. Unplug the cabinet from the power supply, and unplug any lit sign panels.
2. Remove the front panel from the top of the
cabinet.
WARNING: Front panel is heavy, a two person lift is
recommended.
3. Brush the condenser coil with a soft brush to
remove any dust and fluff.
4. Refit the sign assembly and reconnect to the
power supply.
Important
When refitting, ensure the tabs on the back of the
sign are located in the notches on top of the cabinet,
and that the sign is pushed fully in and secure.
Apple App
store
Google Play
store
Coil
Tab and notch
-
1
-
2
-
3
-
4
Skope ActiveCore Freezer User manual
- Category
- Fridge-freezers
- Type
- User manual
Skope ActiveCore Freezer
The ActiveCore Freezer is a high-performance refrigeration unit designed for demanding commercial use. With its advanced features and robust construction, it offers reliable and efficient temperature control for a wide range of perishable products.
Key Capabilities:
- Precise Temperature Control: Factory-set for storing perishable products at -18°C or below, ensuring optimal preservation and food safety.
- Adjustable Shelves: Customizable shelf heights allow for flexible storage arrangements to accommodate various product sizes.
- Internal Airflow Optimization: Designed to maintain consistent temperature distribution throughout the cabinet, preventing product spoilage due to uneven cooling.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Skope ActiveCore Freezer User guide
-
-
-
-
-
-
-
-
-
Other documents
-
scope reflex series User manual
-
-
Serene HB80-2 User manual
-
Serene HB400 Operating and Service Manual
-
-
Haier HB80 Installation And Operating Instructions Manual
-
-
-
True TAC-14GS-LD User manual
-
Maytag Integrated Side by side refrigerators User manual