DOUG S HEADERS D3358 User manual

Type
User manual
Installation Instructions & Warranty Information
D3358 ~ 1970-81 Camaro, LS Engine Swap Mid Length Headers
REV. 1 11-30-21 DSL
Notes:
1. TheseheadersaredesignedspecicallytoworkwithDoug’sEngineSwapmotormount
 brackets#SK103.Wecannotguarantytwithanyotherbrand.
2. Willnotworkwithfactorycolumnshifters.Ifusingacolumnshiftautomaticyouwill
 needtofabricatelinkageoruseacableconversionkit.Ifusingamanualtranswe
 recommendaoorshifterandhydraulicclutchconversion.
3. Doug’sD3358aredesignedtobeusedwithmostGMautomatictransmissions 
aswellasT56andT56Magnumstickshift.SeeDoug’stransmissioncrossmember
 #SKC1021formoreinformation.
4. Doug’soersabolton3”Exhaustsystemforthisheaderapplication,part#DES104
 andmidpipesDMP104,DMP105toconnecttheheaderstotheexhaustsystem.
5. AngleBootSparkPlugwiresarerequiredwiththeseheadersWerecommendPerTronix
 CeramicBootwires#808224HTor828224HT.
DISASSEMBLY
1. WerecommendthattheDoug’smotormountsandtranscrossmemberinstallationare
 nishedbeforeattemptingtoinstalltheheader.Disconnectthenegativebatterycable
 fromthebattery.
2. Ifacarliftisnotavailable,raisethevehicle2feetorhigherandsupportitwith 
 adequatesafetystands.Makesurethevehicleisonaatsolidsurfaceandisstable.
3. Removethesparkplugwiresandplugs,thentheOildipstickandtube.
4. Ifthemotorhasexistingmanifolds,removethem,andcleanthematingsurfaceonthe
 cylinderheads.
INSTALLATION
1. Applyadabofanti-seizetothesuppliedheaderbolts.
2. Startingwithpassengerside,sliptheheaderinplaceworkingfromaboveandholdin
 placewith1headerbolt.
3. Fromabovesliptheheadergasketinplaceandthenstarttheremainderiftheheader
 boltsandlockwashers.
4. Tightenallheaderboltsevenlyworkingfromthecenterout.
5. SliptheDriverssideheaderintoplacefromabove.Aswiththepassengerside,install
 thegasketandalltheheaderbolts,tighteningfromthecenterout.
6. Reinstallthedipsticktube,sparkplugsandwires.
7. IfusingtheDoug’sMidPipes#DMP104,DMP105,slipthemontothecollectors,butdo
 nottightentheclampsuntilyoudotheexhaustinstallation.Installyour02-sensors,use
 adabofAntiSeizebeingcarefultonotgetanyonthe02-sensorprobe.
9. InstalltheDoug’sExhaustsystemtocompletetheinstallation.
PARTS LIST:
1 Left side header 1 Right side header
2 Header gasket 12 Header bolts M8-1.25 x 25MM (1” long)
12 Lock washer, 3/8”
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

DOUG S HEADERS D3358 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI