Thank you for buying an Angelo Décor Fountain!
We hope you will find these instructions helpful in setting up your fountain.
If you have any issues with this item, please DO NOT return the unit to place of purchase.
Please visit our web site, www.angelodecor.com, for assistance and warranty information.
First unpack carton carefully, arranging parts safely in your working area.
Feed the cord through the cord pipe. Feed the cord down and
through the pedestal and
align it with the groove at the
base.
Set the pump housing
/ riser into place by
Feed the tubing up the
pump housing / riser
and
Set the second
bowl in place by
Carefully place the large bowl
on the pedestal by aligning the
grooves as shown.
The pump should sit flat inside the
bowl as shown above. Attach the
included tubing to the pump.
The riser is installed next. After feeding the tubing
Now simply fill with clean water and plug into a grounded GFCI outlet
We recommend keeping bowl 3/4 full of water to avoid pump burnout.
Product must be properly stored for winter.
The final assembly should look
like this
/ riser into place by
aligning the grooves.
pump housing / riser
and
pass it through the middle
of the second bowl.
bowl in place by
aligning the
grooves.
Pass the tubing through the
last bowl and set in place
with grooves aligned.
Connect the tubing to the
top piece.
through the riser, slide it in place with the grooves
aligned.
Align the grooves and
set the top in place.
Check to ensure the tubing is still properly
attached to the pump and install the pump
access door. This feature makes it easier for
you to clean and adjust your pump.
This fountain comes
complete with our innovative
splash reduction system. If
splash is a concern, simply
drape the splash line over
each spill point to
dramatically reduce splash.
/
