AcraDyne iEC4EGV Operating instructions

Brand: AcraDyne

Model: iEC4EGV

Type: Operating instructions

The Gen IV controller has the ability to

communicate over the Chrysler PFCS protocol

over Ethernet or one of the serial ports. Once the

controller is connected to the desired network,

several parameters are used to congure its

behavior on the PFCS network.

From the main menu, select Controller.

Select Protocols.

Then select PFCS.

• Server IP Address:

The IP address of

the PFCS server.

If the server is on

another sub-net,

verication of the

gateway in the

Ethernet settings

is required. This

parameter is not

used for a serial

connection to

PFCS.

• Server Port

Number: The

TCP port server

is listening for a

new connection.

Parameter is not

used for a serial

connection to

PFCS.

• Acknowledge

Time Out (sec): Amount of time controller will wait

for an acknowledge from the PFCS server.

• Number of Retries: Number of times controller will

retry a message if not answered by the PFCS server.

• Reconnect Time Out (sec): Amount of times

controller waits before attempting to re-connect

to PFCS server.

• Connection Inactivity Time (sec): Amount of time

controller waits before sending a “keep alive”

message.

• Auto Machine ID: When boxed is checked,

controller will request a machine ID from PFCS.

When box is not checked, controller will use the

programmed one from each parameter set.

Gen IV Controller

PFCS Instructions

QUALITY • INNOVATION • SERVICE LIT-MAN177_PFCS

07-07-22

CORPORATE HEADQUARTERS

10000 SE Pine Street

Portland, Oregon 97216

Phone: (503) 254–6600

Toll Free: 1-800-852-1368

AIMCO CORPORATION DE MEXICO SA DE CV

Ave. Cristobal Colon 14529

Chihuahua, Chihuahua. 31125

Mexico

Phone: (01-614) 380-1010

AcraDyne iEC4EGV Operating instructions

AcraDyne iEC4EGV Operating instructions

AcraDyne iEC4EGV Operating instructions

Related papers

Other documents