4017 Shotgun Microphone

DPA 4017 Shotgun Microphone Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the DPA 4017 Shotgun Microphone Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
4017C Shotgun Microphone
A combination of the MMC4017 microphone capsule and the MMP-C
preamplifier, the 4017C Shotgun Microphone is part of the Pencil
Microphone Series.
Performance
The supplied calibration chart shows the specially tailored
individual frequency response of the MMC4017 capsule, measured
with a linear MMP-C preamp.
Typical on- and o-axis frequency response of MMC4017
Typical directional characteristics of an MMC4017
dpamicrophones.com/4017
DPI-4017C-QG
Service & repair
If you are not satisfied with the characteristics exhibited by this product, please contact your nearest DPA
Microphones representative for support.
Warranty
4017C is covered by a five-year limited warranty.
CE marking
This product conforms with all relevant directives approved by the European Commission.
20 Hz 50 100 200
500
1 kHz 2510 20 40
dB
10
-10
-20
-30
0
0
°
30
°
60
°
90
°
140
°
16 kHz
8 kHz
4 kHz
2 kHz
1 kHz
500 Hz
250 Hz
0
º
5
dB
Specifications
Directional pattern
Supercardioid, lobe-shaped
Principle of operation
Pressure gradient, with interference tube
Capsule type
Pre-polarized condenser
Frequency response
20 Hz to 20 kHz
Eective frequency range, ± 2 dB, at 60 cm (23.6 in)
40 Hz to 18 kHz with typ. 3 dB soft boost at 15 kHz
Sensitivity, nominal, ± 2 dB at 1 kHz
19 mV/Pa, -34.4 dB re 1 V/Pa
Equivalent noise level, A-weighted
Typ. 13 dB(A) re. 20 µPa (max. 15 dB(A))
Rated output impedance
< 100 Ω
Output balance principle
Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR)
> 50 dB
Power supply (for full performance)
P48 (Phantom power)
Current consumption
2.8 mA
Polarity
+V at Pin 2 for positive sound pressure
Connector
XLR-3M. Pin 1: Shield, Pin 2: signal + phase, Pin 3: signal – phase
Weight
40 g (2.5 oz)
Temperature range
-40 °C to 45 °C (-40 °F to 113 °F)
Relative humidity
Up to 90%
/