Cooper Lighting SURE-LITES PHL Series User manual

Brand: Cooper Lighting

Model: SURE-LITES PHL Series

Category: Wall & ceiling mounts accessories

Type: User manual

This manual is also suitable for

PHL Series

Cooper Lighting SURE-LITES PHL Series is a photoluminescent EXIT sign that requires only 5 foot-candles of external fluorescent illumination to charge and has a long lifespan. Installation is easy and can be done by following the steps outlined in the instruction manual. The sign is suitable for both top mount and end mount installations, and can also be surface mounted. It comes with a variety of mounting options, making it easy to install in any location. The sign is designed for indoor use only and has an operating temperature range of 10-40°C (50 – 104°F).

INSTALLATION

Step 1. Separate the two EXIT panels by sliding the panel facing the installer to

the left, and the rear panel to the right (see illustration 1).

Step 2. Remove unneeded directional chevrons from the sign (see illustration 2).

Step 3. Secure the remaining chevrons by bending the outer tabs at the point of

the chevron on the back of the EXIT panel. Do not bend the two inside

chevrons (see illustration 3 and 4).

Top Mount or End Mount

Step 1. Reassemble the two panels by performing the reverse of Installation

Step 1 (see illustration 5).

Step 2. Align the four holes on the U-channel insert to the matching holes on the

sign, in the desired mounting location. Attach the aluminum U-channel to

the sign using the four screws provided (see illustration 6).

Step 3. Apply the silver screw hole covering strips to the unused holes

(see illustration 7).

Step 4. Affix the external aluminum mounting bracket to the wall or ceiling, using

suitable mounting means. If attaching the mounting bracket to a drop

ceiling, use the drop ceiling reinforcement plate and screws provided.

Step 5. Slide the U-channel into the mounting bracket (see illustration 8).

Step 6. Snap the plastic endcaps into both sides of the mounting bracket/

U-channel assembly to complete the installation.

SURE-LITES

Installation Instructions for the PHL Series Photoluminescent EXIT

Photoluminescent EXIT sign, requiring only 5 foot-candles of external fluorescent illumination to charge.

Operating temperatures from 10-40°C (50 – 104°F), Indoor Use Only.

IMPORTANT SAFEGUARDS

WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS

BE OBSERVED INCLUDING THE FOLLOWING:

1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS

2. Do not use this equipment for other than the intended use.

3. Installation is to be performed only by qualified personnel.

4. Install in accordance with National Electric Code and local regulatory agency requirements.

5. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.

6. SAVE THESE INSTRUCTIONS.

Customer First Center 1121 HIGHWAY 74 SOUTH PEACHTREE CITY, GA 30269 3/07 11554915

INCLUDED HARDWARE:

A. U-channel

B. Mounting Bracket

C. End Caps

D. Drop Ceiling Reinforcement Plate

E. Hardware Package

Illustration 1 Illustration 2 Illustration 3 & 4

TOP VIEW

SURE-LITES

Customer First Center 1121 HIGHWAY 74 SOUTH PEACHTREE CITY, GA 30269 3/07 11554915

Surface Mount

Step 1. Using a drill, self drilling screws, or other appropriate means, create mounting holes on the back panel in the necessary locations (see illustration 9).

Step 2. Attach to the wall using suitable mounting means.

Step 3. Reassemble the two panels by performing the reverse of Installation Step 1 (see illustration 10).

Step 4. Apply the silver screw hole covering strips to the edges.

Maintenance

Periodically clean letters with a damp cloth.

Illustration 5 Illustration 6 Illustration 7

Illustration 8 Illustration 9 Illustration 10

TOP VIEW