NGM EVO is a numerical control system based on the Freescale MCF52259 microprocessor. It features a 192Kb flash memory, 32Kb of RAM, 16/32Kb of FRAM permanent memory, and various input/output ports, including Ethernet, RS232, CAN, analog inputs and outputs, and digital inputs and outputs. The system allows for the control of up to four stepper motors with a maximum frequency of 400KHz in position mode and 125KHz in interpolation mode. It also supports the CANopen protocol for communication with other devices.
NGM EVO is a numerical control system based on the Freescale MCF52259 microprocessor. It features a 192Kb flash memory, 32Kb of RAM, 16/32Kb of FRAM permanent memory, and various input/output ports, including Ethernet, RS232, CAN, analog inputs and outputs, and digital inputs and outputs. The system allows for the control of up to four stepper motors with a maximum frequency of 400KHz in position mode and 125KHz in interpolation mode. It also supports the CANopen protocol for communication with other devices.
NGM EVO is a numerical control system based on the Freescale MCF52259 microprocessor. It features a 192Kb flash memory, 32Kb of RAM, 16/32Kb of FRAM permanent memory, and various input/output ports, including Ethernet, RS232, CAN, analog inputs and outputs, and digital inputs and outputs. The system allows for the control of up to four stepper motors with a maximum frequency of 400KHz in position mode and 125KHz in interpolation mode. It also supports the CANopen protocol for communication with other devices.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI