Zip-Rip ZR1RD Installation guide

Type
Installation guide
Tape Measure
STEP 2
Rotate the Clamp around
and over the end
of the Tape
Measure
to align
the hole
in the
Base Component
with the hole in the
bottom of the Clamp.
Insert second screw
through the bottom
of the Base Component.
Tighten both screws firmly.
Tape Measure
STEP 1
1A. Insert one screw
up through the
bottom of the
Base Component
and into the Clamp.
Tighten slightly.
1B. Place the end of the Tape Measure
into the slot of the Base Component.
Zip
Rip Tape Measure Attachment
Assembly Instructions
Base Component Top Clamp Two (2) Screws
Parts List
Warranty Information
Thirty (30) day money back guarantee.
  • Page 1 1

Zip-Rip ZR1RD Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI