Zebra ST6080 Owner's manual

Type
Owner's manual
Page 1 of 2 Part No. 1005974 Revision A
Installation Instruction for ST6080 Rubber Boot
1. Installation of the ST6080 Yellow Rubber Boot for Standard Back
STEP 1.
INSERT HANDHELD THROUGH
OPENING IN THE RUBBER BOOT
AS SHOWN IN FIGURE A.
STEP 2.
SECURELY FIT THE FRONT
END OF THE HANDHELD IN
THE END OF RUBBER BOOT.
SEE FIGURE B.
Continued on other side…
Figure A
Figure B
Page 2 of 2 Part No. 1005974 Revision A
STEP 4.
FIGURE E SHOWS THE
COMPLETED ASSEMBLY
OF THE RUBBER BOOT.
STEP 3.
FIRMLY PULL BOTTOM CORNERS OF RUBBER BOOT (ONE AT A TIME
WORKS BEST) AROUND THE END OF THE HANDHELD UNTIL SECURELY
ENCLOSED. AS SHOWN IN FIGURES C AND D.
Appendix A: Support Services
Fortechnicalsupport,pleasevisittheSupportsectionofourcommunityIngenuityWorking:http://community.psion.com/support
.
Figure C Figure D
Figure E
  • Page 1 1
  • Page 2 2

Zebra ST6080 Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI