Kichler Lighting 42894CH User manual

Brand
Kichler Lighting
Model
42894CH
Type
User manual
Date Issued: 06/10/16 IS-42894-US
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main fuse
box before starting and during the installation.
1) First rotate the fixture arms to 60 degrees.
2) Slide the lower cup up to the body and screw the crystal
finial up to the lower cup until snug to hold the lower cup
into place.
3) Screw in the (5) three studded ball knobs into the top of the
arms securely.
4) Pass fixture wire thru threaded hole in first loop. Thread loop
onto the nipple that protrudes from the top of the fixture.
Tighten to secure.
5) Pass fixture electrical wire and ground wire through item
“A” with hexnut and screw into the fixture bottom as shown,
tighten the hexnut snugly. Slide item “B” over item “A” and
place trim onto item “B”. Place item “C” onto the trim and
thread the loop onto item “A” and tighten down against item
“C”. Attach the chain to the loop and weave the wire and
ground wire through the chain.
6) Take threaded pipe from parts bag and screw in screw collar
loop a minimum of 6 mm (1/4”). Lock into place with hexnut.
7) Now screw threaded pipe into mounting strap using sup-
plied screws. Mounting strap must be positioned with
extruded thread faced into outlet box. Threaded pipe must
protrude out the back of mounting strap. Connect mounting
strap to outlet box.
8) After desired position is found, tighten top hexnut up
against the bottom of the mounting strap.
9) Slip canopy over screw collar loop and thread on threaded
ring. Attach chain (with fixture connected) to bottom of
screw collar loop. Unscrew threaded ring, let canopy and
threaded ring slip down.
10) Pass wire through threaded ring, canopy, screw collar loop,
threaded pipe and into outlet box.
11) Make wire connections per 14 instructions below.
12) Get the (5) three crystal finials and thread up into place on
each arm below the sockets.
13) Slide the bobeche over the sockets.
14) Grounding instructions: (See Illus. A or B)
A) On fixtures where mounting strap is provided with a
hole and two raise dimples. Wrap ground wire from
outlet box around green ground screw, and thread into
hole.
B) On fixtures where a cupped washer is provided. Put
ground wire from outlet box under cupped washer and
green ground screw and thread screw into hole in
mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector,
after following the above steps. Never connect ground wire
to black or white power supply wires.
15) Make wire connections. Reference chart below for correct
connections and wire accordingly.
16) Pass fixture wires thru hole in canopy. Make sure open side
of canopy faces ceiling. Pass canopy over the (2) mount-
ing screws and using the (2) two lockwashers and (2) two
slotted lockup knobs secure the canopy to the ceiling. Make
sure all wires are inside canopy and do not get pinched
between canopy and ceiling
17) Insert recommended bulb (not included).
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
A
B
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
Date Issued: 06/10/16 IS-42894-US
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
OUTLET BOX
WIRE
CONNECTOR(S)
STRAP
MOUNTING
SCREW(S)
GEMSTRAP
WITH GROUNDSCREW
HEXNUT
THREADED
NIPPLE
CANOPY
SCREW COLLAR
LOOP
THREADED
RING
CHAIN
LOOP
(5)STUDDED
BALL KNOBS
(5)CRYSTAL
BOBECHE
(5) CRYSTAL
FINIAL
LOWER
CUP
Page is loading ...
Date Issued: 06/10/16 IS-42894-US
Estamos aquí para ayudarle 866-558-5706
Horario: Lunes-Viernes 9am a 5pm EST (hora oficial del este)
CAJA DE SALIDA
CONECTORES
DE ALAMBRE
TORNILLO DE
MONTAJE DE LA
ABRAZADERA
GEMSTRAP CON
TORNILLO DE TIERRA
TUERCA
HEXAGONAL
NIPLE
ROSCADO
ESCUDETTE
OJAL DE
COLLAR ROSCADO
ANILLO
ROSCADO
CADENA
ANILLO
(5)TACHONADA
PERILLA
DE BOLA
(5)BOBACHE
DE CRISTAL
(5) FINIAL
DE CRISTAL
COPA
INFERIOR
Page is loading ...
Date Issued: 06/10/16 IS-42894-CB
INSTRUCTIONS
For Assembling and Installing Fixtures in Canada
Pour L’assemblage et L’installation Au Canada
Nous sommes là pour vous aider 866-558-5706
Heures : du lundi au vendredi, de 9h à 17h (heure de l’Est)
BOÎTE À PRISES
CONNECTEURS
DE FIL
VIS DE L’ÉTRIER
DE MONTAGE
GEMSTRAP
AVEC VIS DE TERRE
ÉCROU
HEXAGONAL
RACCORD
FILETÉ
COUVERCLE
BOUCLE DU
COLLIER À VIS
BAGUE
FILETÉE
CHAÎNE
BOUCLE
(5)BOUTON
BOULE CLOUTÉE
(5)CRISTAL
BOBÈCHE
(5)FLEURON
DE CRISTAL
INFÉRIEUR
COUPE
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Kichler Lighting 42894CH User manual

Brand
Kichler Lighting
Model
42894CH
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents