Installation Guide for PVC Pipe Slip x Slip 45 degree Elbow
If the pipes needing joined form a 45 degree angle or turn and both ends have smooth ends, you
would use a 45 degree slip (or slip x slip) elbow. Schedule 40 PVC 45 degree ells are designed to
turn the flow of a liquid at a 45 degree angle. Both pipe ends are glued into the ell, forming a 45
degree turn or joint.
Steps:
1. Before you try to fit your ends together wipe down both pipe ends and inside the elbow and
apply PVC glue
2. Once your sealant is applied insert the 2 PVC pipe ends into the 45 degree Elbow.
3. Wipe off excess pipe glue
/
